Projector sharp projector XR 1 S lamp is not working

hi,
for resetting the lamp hour do the following

1. Plug the power cord into the AC socket of the projector.
2. While simultaneously holding down MENU/HELP, ENTER and DOWN ARROW button on the projector, press STANDBY/ON on the projector.
3. "LAMP 0000H" is displayed, indicating that the lamp timer is reset.


ok

Page 50 to 52 on the link below will tell you how to change the lamp.

http://www.infovideoproiettori.com/proiettori/sharp-xr-20x-manual.pdf

Good Luck

Reset the lamp timer: While simultaneously hold down Menu/Help,Enter and v down arrow button on the projector.Your projector lamp hour show "0000H"

It is mother board problem.Reverse side of the board 5 pin ic not giving 12 volt.pin no. 1 input 12volt and pin no.3 12 volt out.it might be damage

You should consider using original lamp from sharp before some generic lamp destroys the ballast or power supply of the projector.

yes. it's an AN-XR10LP/1.

if it's under 1 year old, it's still under warranty, so send it in and get it fixed for free.

first, make sure you have the correct lamp. the lamp for the xr-10x-l looks like the xr-10x, but the plugs are different (common mistake). make sure you have the AN-XR10L2/1, not the AN-XR10LP/1. to reset the lamp timer (with the projector plugged in but off), hold down the enter, down arrow, and menu buttons and press the power.

Sounds like the lamp needs to be replaced.
Re your Sharp XR 30S We are able to supply replacement lamp delivered (excluding local your local taxes) for $US270 as we ship internationally and also the same with our revolutionary ICE Digital Daytime projection screens.
http://www.youtube.com/watch?v=HvZ2DlVJ790 http://www.youtube.com/watch?v=qL_44xfK9y8 Regards Kevin Andreassend ICE AV Technology Ltd http://www.digitaldaytime.com [email protected] +64-9-414 2348

need to replace the lamp. i could have diminished not as much to frequent on and offs, but excessive dust. it's heating up too much and shutting down.