I'm looking for an owners manual for the New Air ACP 1000E. My wife is a teacher. The school got her one of these for her room, but the custodians took the manual, so when their is an "error" message she has no way to fix it without waiting 2 or 3 days for the maint. guys to come around.

NewAir ACP 1000H Owner Manual

Hi,
No, a byproduct of cooling the air is condensation....or dehumidification... so in short.. if you want to cool the air you will also dehumidify it...

heatman101

if it is also blowing cold air out of the other vents you need to vent the hot air its blowing outside

Hi,

Here is a tip that gives a further explanation of that E-1 code. The causes of the E-1 code can be varied depending or the brand of your air conditioner.

Read through this tip... it will help you understand what is happening with your window air conditioning unit and give you some things to try to help you get your problem resolved.

E-1 Code on Window Air Conditioning Units

heatman101

Check the float thaat is the sensor to indicate the water level to the micro controller. The wires are cut or the float is deffective .
Check and replace.Credit if helpful with this tip.

http://wize.com/air-conditioners/t17007-manual

that means the water condensate tank is full, you must unplug the unit, take it outside, unscrew the condensate tank plug cap, pull out the black rubber plug and let the water flow out until empty. then replace the plug, screw cap back on, roll inside, plug in and resume cooling. good luck! :)

Buy some 1/2 thick rubber pads and put it under the unit, I am assuming it is on rollers or has feet. This should eliminate some of the problem

Check whether you have set the OFF timer.

Check thermostat / thermistor.

I think it may be a blown fuse.... My unit is doing the same thing except I'm not getting an error code on the display. I opened the unit and checked the fuse, it was definitely blown. I have to wait till tomorrow to get the new fuse to see if that fixes the load beeping and the non-responsive display.