The 9 flash error usually means an issue with one of the power supply boards in the TV. You can verify this by bypassing the shutdown. To do this with the set off and in the standby mode point the Sony remote at the TV and press these buttons in sequence within 5 seconds of each other, DISPLAY 5 VOLUME DOWN and then POWER. The set should turn on with no issues. Once it comes on there will be a diagnosis screen and the bottom entry on the screen should be ZCD. That entry should have a zero in the fail column. If it has anything besides zero then the power supply board is at fault. There are two power boards in this TV so I don't remember which one causes the issue whether its the G1 or G2 board. At this point if this is the issue then I would have a technician do the repair since replacing either board isn't that easy. Please take a few moments to rate my answer. Thank you....
Testimonial: "it really worked! Now how do I turn the diagosis window off?"
Unfortunately you can't turn the diagnosis screen off. It will go off when you power the set down and power it back up the normal way. It just proves the point that the ZCD circuit is failing and you will have to have the power supply board replaced. I just thought I'd help you do a little troubleshooting...
×
287 views
Usually answered in minutes!
×