I have a traffic reciever antena that plugs into my tom tom, i have never used it, i dnt know how too? do i need to subscribe to anything or is it just plug and play? when i switch my tom tom on how do i activate it?

Handling Process
Try to test on Huawei ONT:
- Used toolbox to analyze the traffic at ONU.- Took traces w.r.t to telno. and V5 id.- No problem found in V5.2.- Checked the ts status using dynamic view of timeslot for PV4 card at the ONU and found timeslots were almost fully occupied at busy hours.- Added one more E1 to ONU and observed the traffic, problem was resolved and had enough timeslots available for subscribers.
Root Cause
E1s assigned to ONU are not as per subscriber load and all E1 Timeslots occupied soon in peak load hours.
Suggestions
- Project Erlang calculation should be calculated specifically for each ONU as per expected subscriber load instead of full network.

HI,

PLease CLICK HERE
to subscribe for that feature..

You must have the correct Traffic Receiver plug , its the car cigarrete lighter adapter it has 2 lights on the plug in one will be Green for power the other may be Red if Traffic is not subscribed yet, so you might have a green and red showing.

If you have already have Traffic once you navigate to where you want to go, and the Car Adapter plug has to be used, go to Menu...Tools...Traffic

You can also check when the Car adapter plug is used, Menu...Tools...Traffic it will say if you have the Lifetime Traffic subscription if not...the following will get you going

First you must subscribe to the FM Traffic .... Premium Traffis Subscription by Navteq-North American
Go to www.Garmin.com under the Extra tab you will see Services.... Traffic

started to work again with no intervention. This seems a service fault!

If you're using a RDS-TMC, then you don't need to go through Tom Tom Traffic. The traffic bar should show up on the right-hand side of the screen, and you're good to go.

If that bar isn't showing up, here's what to do:

Reset the navigator (use a paperclip in the hole on the bottom of the unit). Plug the RDS-TMC antenna into the navigtor. Plug the car charger cable into the RDS-TMC antenna. Turn on the Tom Tom.

Is there a traffic information bar now?

You can purchase a traffic receiver through Tom Tom here:

http://www.tomtom.com/services/service.php?id=44

or here:

http://www.tomtom.com/products/accessories/accessory.php?ID=804


The device depends on external transmitters broadcasting traffic data. I'm not certain that the service is even available in South Africa. Please check to make sure you can use it before you purchase anything.

because tom tom uses the bluetooth connection via your cell phone to obtain traffic conditions on the newer verision of tomtoms they use the rds signals 

Try resetting the Tom Tom.

Use a paperclip in the reset hole in the bottom of the navigator. See the manual for more details on resetting.

Often this problem is caused by unplugging from the antenna while the navigator is still turned on.

sounds like a service issues try taking it to your company

Trash can it and buy a new T.V.