The dryer gives E68 it starts running dor 30

Frigidaire Dryer That Has Error E68 and stops every 30 Seconds The Laundry...
Visit this site to get more details.
https://www.6ya.com/
http://electronicshelponline.blogspot.com/

E68 for this model number says in manual that this is for a "button stuck" or held down for more than 30 seconds

ck all your buttons for one that just doesn't "feel right" when its pressed , this one will be your problem

Bad venting causing overheat? bad thermostats hi limit and cycling? thermal cutt off. bad moister sensor in the drum? giving wrong reading and cuting it off?

Good Afternoon David,

I understand that your Frigidaire Affinity dryer, model# LEQ6000ES2, is showing you an error code of E68 and will not start. I also see that you have changed the thermal limiter. Looking at what the E68 error code means, a key or button stuck, there could be something else causing the code to come up. I suggest contacting your local authorized technician for further assistance. They will be able to diagnose your appliance, determine what is causing the E68, and repair your dryer. Hope this is helpful.

-Best Regards-
WP

Good Afternoon Friend, this is Z. Thank you for your post!

If you are getting an error code E68 on your Frigidaire dryer, it usually indicates that one of the keys (buttons) is stuck closed (active). Let's try entering a "Function Test Mode" and perform Key Test to determine which button is at fault. To perform the "Function Test Mode": Press and hold the START and CANCEL button at the same time for 10 seconds. The stuck key should blink. Carefully free the key and perform the test again after proper diagnosis. If button is free but the error code still exists, the electronic control will more than likely need replacing after proper diagnosis. If you do not have a professional connection, you have the option to visit the manufacturer website to find a service provider in your area. Hope this helps!

E68 is a stuck button on th control panel

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Please click the link below to see my answer to a similar E68 question on fixya:
https://www.fixya.com/support/t10225683-error_code_e68_frigidaire_affinity

e68 code

this is a fault code that means there is a stuck key on the board you may have to remove the control panel and check the keys if this does not work you may have to replace the panel or control board

Good luck

I would contact customer support for Frigidaire. They will porbably be able to give you an idea. I would bet it is the dryer cord that could be bad.

E68 error code, according the manufacturers operations manual found at this link: ftp://ftp.electrolux-na.com/ProdInfo_PDF/Webster/134431300esa.pdf

Says the the button used to start the machine has either malfunctioned or is "STUCK" in the start postion. Read this link I found and see if it helps. Best of luck to you.