Hi i have a yamaha rx-v995 reciver and just percase new pioneer dv-320 dvd. it's output connection is with coaxial conector.when i connect the coaxial to the coaxial onector of my yamaha reciver i dond get any sound. what can i do to be able to oparte the coaxial input of my reciver?

Connect the EQ to the Tape IN and OUT jacks and switch the Rec OUT/Zone 2 to Tape/MD. That is my best guess without having the owners manual....

I'm confused. The message header shows a problem with a Yamaha RX-V995 receiver.

As for connecting a Nakamichi (or any surround system) to a TV - the only connection would be the Monitor output (video connection) to an appropriate video input of your TV.

If it is a Nakamichi, it is a little older and probly predates the invention of HDMI cables. My guess is you will either use the S video output or Composite video output to the TV's input with similar connections.

This allows you to route whatever video sources you have connected to the Nakamichi to the TV.

Have you tried the another optical cable? They don't tolerate dirty connections or small-radius bends in their routing. THAT (and the expense of optical cables) is why I always choose coaxial connections when possible.

the coaxial cable from outside is connected to in (box), coaxial cable from out to digital in (RX) digital out to TV... (try scrolling through source to cable/ or component if this is HD) (all other devices can be connect to RX also like dvd using Red Yellow White cable or S-video w/red & white)

your main lead wire contains only two core, could be brown, black, anyway..open the cover of the unit, and change the cord, get three core main wire, and take the old one off, replace the other one, which should have earth, you can screw it to the transfomer base, try this

Try getting into the configuration menu of the MP3 player and adjust the output controls for external devices....it sounds to me like it might be too high and/or the wrong output decoding.

I'm in the same boat w/ my v995 - it has a bad volume motor and its $150 for the part. You want to sell your v995? Adam

I suggest you run self diag.  press [FM/AM] key + [Input mode] key and press the [power/standby] switch.

ps prt = power supply problem
dc prt = shorted output or leakly cap in channel
tmp prt means to hot on heatsink

you'll likely have to measure the resistances of the output FETs to find a short, 

Hi and welcome to FixYa,

Initially, a workaround:

• as you posted, audio out of the DVD goes to the receiver;
• HDMI out of the DVD goes to the Schaub Lorenz LCD.

Even if it were a compatibility issue or HDMI processor issue on the receiver, the above should get you going.

Good luck and Thank you for using FixYa. Happy Holidays.

I don't think this has an Optical but a Coaxial connection. You might try a coaxial audio cable not optical.