Hi Andy in regards to your solution, how to "TAKE THE FUSER OUT CHECK THE THERMISTORS" were is thermistor? "check electrical connections in fuser. check thermister, thermostat, fusing lamp etc. with the help of multimeter.?
replace the defective parts in the fuse" how?
Hi
Thanks for using FixYa. This error mostly occurs due to power outage. This
error means that the fuser temperature and hot roller temperatures have warm
up. After occurring of this error the printer will not work until your clear
this error code.
To clear this error code
follows this step by step procedure---
This will resolve
the issue by clearing the error code.
Please do rate the solution and revert for further assistance.
Thanks
Rylee
SOURCE: Ricoh copier MP 6000 error code
THIS IS USUALLY FOR THE FUSER SECTION IT MAY BE THAT SOME TONER HAS BUILT UP ON THE THERMISTOR AND IT AINT READUNG THE TEMP PROPERLY AT WARM UP OR ON A RUN IT HAS TO OVERHEAT TO GET RIGHT READING TAKE THE FUSER OUT CHECK THE THERMISTORS.. YOU COULD ALSO GO INTO THE SERVICE MODE VIA CLEAR ALL THEN 107 AND HOLD DOWN THE RED STOP BUTTON TILL THE SCREEN CHANGES IF YOU LOOK FOR COPIER SP IN THE FEED SECTION THE FUSER SETTINGS ARE THERE YOU CAN OPEN FUSING TEMP AND CHECK THE TEMPS AT THE TIME TO SEE IF THEY ARE RIGHT.. IF IT SEEMS RIGHT IT MIGHT HAVE BEEN A READ ERROR AND BY GOING INTO MODE AND LOOKING FOR 5- 810 YOU CAN RESET THE SC TURN OFF AND THEN BACK ON IT SHOULD CLEAR... GOOOD LUCK A
SOURCE: error message of SC542
The problem is related to fusing temperature.
To resolve the problem, enter the SP mode : press the keys as per sequence given :
<clear modes(yellow)> <1> <0> <7>
keep STOP (red) key preseed for 3 seconds,
enter copy SP mode, Use OK or # keys.
press : 5 # 8 1 0 #
change the value from 0 to 1
turn the machine OFF and ON.
If the problem reoccurs, ckeck electrical connections in fuser.
check thermister, thermostat, fusing lamp etc. with the help of multimeter.
replace the defective parts in the fuser
SOURCE: error code SC542, unable to clear message from
this is an error for the fuser heat up..the temp is not being maintained or fluctuations. try this press the yellow clear button at top of number pad then enter 107 and hold down the red cancel button..the screen will change enter the copier sp and select 5.mode arrow down to 5-810 sc reset and execute.turn machine off.. if the code disappears it could have been just a glitch if not check the fuser to see if there is heat coming from it the lamps will come on at te start up. you can check this by putting a screw driver in the actuator slot to cheat the door switch if you see the lamp come on then you may just have to clean off the thermistors .. open the fuser up with the top screws and check that there isnt any build up of toner on thermistors..hope this helps good luck A
373 views
Usually answered in minutes!
×