Remote code for GE TV M#31gt660

Ur girl friend clean around did she unplug the tv.Replug it back later?Bet u she did,that why the tv universal codes is gone.Reprogram ur tv unverisal codes again should solved this problems.Tries push the manual control button channel up like one or two times tv will be in input video again like video 1 or 2.

My only suggestion would be to purchase a multi-functional remote that you could program to your TV. Now some remotes have to be programed buy your old remote. That is not what you need. You need the kind that comes with a little book that will list your tv model number and give you a code (usually 4 numbers) to teach it to talk to your tv.

Your switch at tv are bad, need to replace switches first.

The only way is with the remote. Try to find a GE or RCA universal remote. These remotes are designed around GE and RCA tv's and generally don't have to be programmed. (GE and RCA are both THOMSON made sets). Thanks

Hello,
I had the same issue, turns out all I had to do was change the channel to 00, then my games or whatever I hooked up to the component inputs in the back worked like a champ.

Hope that helps.

use tv/video or input button to switch to av input

I had the same problem. I found the solution in this link.
http://www.techlore.com/forum/thread/13480/?page=1
The only thing that wasn't clear was how to get into the service menu. With the TV on, press and hold the MENU button on the front panel of the TV and press POWER then press VOL+.

If there is no input button on the tv itself to change the input then you will most likly need a remote. so you can get a universal remote and follow the instructions to adapt it to your set then you can use it to change the input. (you can get a universasl remote for like 10$) hope it helped

The GE (actually RCA) 31GT660 uses the CTC187 series chassis. This chassis is notorious for bad solder joints on the shields around the tuner and microprocessor. When the solder joints on the shields crack, the microprocessor and EPROM lose their ground and the EPROM's data becomes corrupt. The solder joints on the shields will all have to be resoldered and the EPROM reprogrammed or replaced by a qualified tech familiar with the 187 series chassis.

have tech repair your tv the video circuit or related circuit is defected.good luck.