Easyshare Z612 with an error code of #e45

You may view/download the user guide here. I don't see E45 listed, but this page may help.

Please learn about error 45 ( e45) here : www.user-guides.co.uk/download/kodak/kodakeasyshare/kodak-easyshare-v705-manual-error-e45.html
www.manualsonline.com/ex/thread/view/idThread/1442587
Regards, Jay

Hi

www.Kodak.com says:
"E45" appears on your camera's display when your camera requires service or repair.

I think it is a lens error. They have a page on www.kodak.com called Step-by-Step Solutions and Repair. This is for USA only.
See what they suggest.

I may be cheaper just to get a new camera.

Hope this helps.

Hello

Firstly, at the link below you can download a updated softcopy of the manual for free.

http://www.retrevo.com/s/Kodak-LS443-Digital-Cameras-review-manual/id/200dj378/t/1-2/

As for the error code you are getting, "error 45" is a lens related problem of LS443.

If the lens is not stuck, you may try to download the firmware from the Kodak site and update the one in your camera.

As the lens is already stuck, there is no choice except to send the camera back to Kodak for servicing.

Hope this can steer you in the right direction.

Kind regards
Andrea

push in da lense, it might work

We downloaded the updated software from kodak, rebooted the computer and it worked great. Thanks for the help.

http://www.digitalcamera-hq.com/digital-cameras/kodak-easyshare-ls443_question.html?qid=5943

Try your luck

I bought one yesterday new for 25 $, so ...............
Bit more plastic then the previous Kodak but 10+ megapixel and video and moving shot ok.

Rate me for a good advice

Its an XML parsing error :
1) shutdown easyshare software from the system tray

2) search for vistaedit.esx on the search box

3) rename it to vistaedit.old

4) open the Kodak Easyshare software again

put the camera in the hearse and take to cemetery and then go buy a new one , you cant take all the money you made with you.

This problem is frequently due to corroded battery terminals inside the camera. Remove the batteries and wipe the terminals with a soft cloth (heavy corrosion may require a fine wire brush, steel wool, or sandpaper). Remove any residue left in the camera by the cleaning. Clean the terminals on the batteries in the same manner, and then replace them in the camera. This cures most problems, but if it doesn't work for you, check the Kodak troubleshooting guide at:

http://www.kodak.com/global/en/service/repair/troubleshooting/troubleshooting.jhtml?pq-path=6198

It uses a simple Q&A format to diagnose problems and propose solutions.