Whirlpool washer Model WTW6600SW2. Error F1

Whirlpool F1 Error

Whirlpool Cabrio F1 Error Control Board W10189966

Appears to be a problem between control board and motor.


Whirlpool Cabrio f1 error and how to fix it

These codes are not usually manually erased, they are overwritten as explained in the service book. Only the last so many codes are stored, beyond that they drop off. Pleazer Appliance...

Pressure Signal Out-of-Range
F then 1 flashes when the control detects an out of range pressure signal.
* Check pressure hose connection from tub to machine/motor control. Is hose pinched or kinked?
* If F then 1 repeats numerous times after POWER is pressed and the pressure hose connection is not pinched or kinked, replace the machine/motor control.

Whirlpool Cabrio F1 error code - NOW A RECALL ISSUE! model # WTW6600SW2 Call Whirlpool or a repair center. The number for Whiripool is 1-800-253-1301

Hope helps.

F1(F68)-Pressure Signal Out-of-Range
I telephoned Whirlpool at 1-800-253-1301. Whirlpool acknowledged the F1 fault and will send a serviceman, free parts and labor, to correct the problem concerning the "famous" F1 fault. This is even for washers out of warranty! This concerns model WTW6600SW2 washers. Be sure to get the authorization code from them so the service person cannot argue about costs.

Whirlpool Cabrio F1 error code - NOW A RECALL ISSUE! model # WTW6600SW2
Call Whirlpool or a repair center. The number for Whiripool is 1-800-253-1301

Whirlpool Cabrio F1 error code - NOW A RECALL ISSUE! model # WTW6600SW2

• I called Whirlpool 1-800-253-1301 today 10/15/08 and they said the F1 issue is now under a recall!

Indicates a fatal error on computer board, WHIRLPOOL has had numerous problems with this issue.I would call Whirlpool to see if they will help

Whirlpool Cabrio F1 error code - NOW A RECALL ISSUE! model # WTW6600SW2

• I called Whirlpool 1-800-253-1301 today 10/15/08 and they said the F1 issue is now under a recall.
• Whirlpool scheduled a repair service -during our phone call- to repair this under a 'recall' & at 'No Charge' to me.
• I'll let you all know how it goes after the repair..

HELLO, Error code F1 indicates a control failure and most likely the machine control board will have to be replaced. Depending on when you purchased the machine, the board may be covered under extended component warranty.
I had the same F1 problem and they had to replace the control board and something relating to the balance. The tech told me this is a common problem.