WHERE IS THE RINGER AND THE VOLUME BUTTONS

If you mean the AT&T 993 two-line speakerphone, you can adjust the ringer volume for each line when the phone is not in use. To increase the ringer volume on the primary line (if set), press the Volume Up arrow. To decrease the ringer volume, press the down arrow. There are 8 different volume levels available for the ringer. The Volume Up/Down buttons are below the * and 0 keys.

To adjust the ringer volume on the secondary line, press that line button (between the Conference and Hold buttons) and then press the Volume Up or Down buttons as needed. (If you haven't programmed a primary line, press a Line button and adjust that line's ring volume before pressing the other Line button. Then adjust the volume for that Line.)

I hope this helps. These directions are shown on page 32 of the manual. AT&T currently has the manual here : https://att.vtp-media.com/ecp/documents/product_Product/227/UserManual/5596/993_manual_i14.pdf . To find this manual or other AT&T phone manuals, start here: https://telephones.att.com/product-support/manuals .

Cindy Wells

You just press the up arrow until you get the volume you desire.

You are indeed lucky!

There is a product that claims, "Did you drop or damage your iPhone 4 causing its buttons to be damaged? This set replaces your existing power, volume and mute switch buttons. Get the new look and feel of a new iPhone 4 with set of buttons."

The cost is only $5.95 and you can check it out by CLICKING HERE

Hi!

To adjust the ringer volume, simply press the left/right arrow buttons, the SF340 must be in standby mode.

Every time you push one of those buttons, the ringer volume will be changed down or up. Volume 0 means no ring.

Please let me know if it helped.

Good luck!

To increase the volume for the ringer, the volume buttons located on the charging stand can adjust the volume. To change the ringer volume on the phone instead of using the stand, go to the menu on the phone and type 1 then 1 again. This will take you to the ringer volume screen. You can select between the options:{1}: Low {2}: Medium {3}: {0}: Off.

To program the volume level of the handset, press the MENU button, then use the up or down arrow buttons to navigate to the HANDSET SETTING menu and press OK. Again using the up or down arrow buttons navigate to the RINGER SETTINGS submenu and press OK. Using the up or down arrow buttons navigate to the RINGER VOLUME submenu and press OK. Use the up or down arrow buttons to select the desired volume level and press OK. Press OFF to end. I have included a link where you can download the manual if you need it.


http://service.us.panasonic.com/OPERMANPDF/KXTG1031.PDF

It's in the "Sounds and Ringtones" setting. You just have to switch the ringer on. There is an easier option. There is a ringer switch located on the side just above the volume control buttons. Slide to turn the ringer and notification sounds on or off. (Red means off.)

T7316 Manual

The volume control adjusts the handset, hands free, headset, and ringer volume. Someone may have fiddled with the buttons and turned the ringer down enough that it doesn't sound when a call is incoming.

VOLUME
While talking, press the VOLUME buttons (left and right
arrows) to control the volume of the handset's earpiece.
There are four volume levels. Press the right arrow (+)
button to increase the volume level, and press the left
arrow (-) button to decrease. VOL 1 is the lowest level and
VOL 4 is the loudest.

the ringer is too loud and the beeps from pressing the buttons are too loud.