No power to motorola dct 6200 dtv receiver

there is no transformer in the power cord just straight wall power. the dct 6200 does all its power stuff inside the cable box.... thats why there is no "block" on the power cord.

Hello
Check out these with your Motorola converter

[1] Verify that the AC power cord is connected to the DCT*
and an AC outlet.

[2] If the DCT* is connected to a switched outlet on another
unit, verify that that unit is powered on.

[3] Press the POWER button on the DCT* front panel instead

of the remote control. The batteries in the remote control
may be depleted

[4] The DCT* may have received a software update and

may not power on while the new software is being
installed. Try again in a few minutes.
OK.

well dct 6200 is pretty old maybe it retired

hit menu and go to the audio section your options are there, make sute to press select on your required audio setting to confirm the change, optical should be automatic when you plug it in while the box is powered on.

http://broadband.motorola.com/dvr/downloads/URMD2.pdf

Hope this helps.

There are three options:

1) Connect the Tivo using the coax output of the cable box into the cable input of the Tivo

2) Exchange cable boxes with your cable provider for one with composite output jacks. It may require you to use a Motorola box that isn't High def depending on what your provider has. I know Comcast has a Motorola HD tuner that has composite outputs as well as component.

3) Upgrade to a Series 3 Tivo. Those units are designed for High Def. Use HDMI cable hookup.

Sent it through the dct guide....menu then setup then cablebox...should see display option either channel or time

turn it off, push the front panel menu button… an onscreen menu will appear that you can navigate with the remote… the last item is reset to defaults.

using your remote hit replay-list-live tv 3 times each it will shut of reset then hit list & will read 0

try browsing to www.motorola.com or try your manual
:D