I have a Jenn-Air W130 electric range and the display is not working and I think I can make out an L1 on the display. Also, when baking the oven makes a whistling sound. Any help????

My 20 year old electric Jenn Air range recently flashed the F7 error code and beeped repeatedly. I shut off the circuit breaker until it cooled. The next day I turned it on and everything seemed fine. We baked a pizza and the
erro repeated when the oven was shut off.
I opened the front panel and noticed the wire ribbon connecting the front panel to the display was slightly askew. How that happened is beyond me. I pulled out the ribbon hold down clips, pushed the ribbon in all the way, and
replaced the hold down clips. The range is now working properly after replacing nothing.
The cheapest fix possible.

Hi. It could be your thermostat not sending power to bake element. If elements are really burning out that fast, check the voltage coming to stove. If more than 220 volts, could be a problem with the power coming into your home. Check also the element if it has continuity.

bake element not working ether bad or wire burnt off

check the power

28" High
24" Deep
30.5" Wide

from tech support

HI. this is a failed oven temp sensor or relay board.

Oven temp sensed; over 600F sensed by control in time of day mode, bake mode, or over 900F sensed in clean mode.


Ohm test the oven temperature sensor, if OK, change power relay board.

mY 27" WALL jENN air blows cold air out the vents when on cleaning cycle. The red buttons aren't lighted. The door locks, otherwise it bakes fine. I wonder if it is really cleaning?

Good Morning!
What youre experiencing could be a result of a faulty oven temperature sensor, a faulty oven control board or relay board. Youre more than welcome to send both the main control board and relay board for evaluation. Fixyourboard will test and repair both as needed for less expensive than buying new, and include a two year warranty.

5700M662 60 Jenn Air OVEN CONTROL BOARD

This means that the Power to element relay energized during time of day display. You have a problem with the wiring harness and it is shorted or you need to change the power relay board (PRB). If it is a double oven, you need to change second oven board.

Every time I have seen this problem, it has been a bad display assembly. These are fairly easy to change yourself, but the part is kind of expensive, I think in the $150-$200 range. Hope this helps!