Broken mixer blades on a bravetti 300watt hand held mixer

HI.This steps might be as well helpful.let me just clarify that you can't even manually twist the shafting.If the motor is working an yet it will not turn the shaft.Tha shafting bossing might as well been broken misallign inside..Better remove the cover by unscrewing it and then try to observe how the motor works.If it really does turn when ever it is plugg on to the source.Observe also misallign bosssing that connects the shafting and the motor's rotor.Thank you for choosing FIXYA.

The prongs on the plug have worn, and the plug can be replaced (for less than $2 USD) from any
hardware store, just cut off the old plug, and wire the new plug onto the cord.
Remember to keep the cord's conductors correctly oriented: the conductor on the Bravetti Hand
Mixer that have the uncolored stripes (in the insulation) is the Neutral conductor, the other is the Hot conductor - assuming your abode is wired to standard US 120VAC.

I realize this is an old post however I have the same issue. The mixer in my opinion is the BEST on the market, or was as the case is. I found that Kitchenaid hand mixer beaters are very similar and work as well as orignals.

Call 1-800-798-7395. I just ordered some for my mixer. Cost $7.95 + $4.95 for 2. Be sure to have your model number when you call.

Model EP552HA

Call 1-800-798-7395 to order

http://www.euro-pro.com/europro/productdetail.aspx?pid=491190D0-ABA5-4597-9189-9015C89A9C3C(Euro-Pro+Base+Catalog)

Look on unit and find maker and call and they will tell you where to find.

You should try JB weld, it has superior strength at holding metallic parts together

amazon for sure... take a look here: Enjoy Life Sweetest Moments with Sunbeam. I hope I have helped. cheers

Call 1-800-798-7398 or go on-line to: www.euro-pro.com for replacement parts for the Bravetti EP545 hand mixer.