Free unlocking code for kdc w3037a

WHEN THE RADIO POWER UP AND U SEE SECURIT CODE PRESS VOLUME KEY UP OR DOWN FOR 3-5 SECOND TIL DISPLAY COME BACK NORMAL

Unfortunately Kenwood codes are only available from the Main Dealer or by using a Radio Decoding Service who will connect a laptop to read the working code inside your radio`s memory chip (EEPROM)

make sure you have no bare or shorted speaker wires and check your speakers to make sure they are all good. if that all checks out, you probably have a bad output ic.

need unlock code bought used car battery died stero needs code dealer has no idea

try 0000 if not 1234, unless previous owner has unlock code its pretty usless

Reset the radio by pushing the small button on left side of the #1 preset. it is probably pulling the code for the anti theft protection. if you already have a lock code use it to unlock the tuner otherwise reset the tuner

Here you go buddy:
http://www.fixya.com/support/r538828-security_unlock_code_kenwood_most_models

Look for a really small hole in the face plate. Put a tip of a pen into it. Press it in and then it should turn on. If this doesn't work, take it to a place that installs them, they'll help....Usually for free....

you have to activ ate the aux port form the menu, on standby hold the menu button and then use the control knob on the right to change the aux to on1

Turn on the car so the radio is flashing "Protect." Look on the front / removable face of the stereo. On it you will find a small round hole - that's a reset button. Find a small paper clip, unfold the clip and stick it gently into the hole. The "Protect" will stop flashing, and Kenwood will be displayed. Unfortunately all your settings/presets will be gone, but at least the stereo is working again!