Microwave blown fuse 5kv 0.75A needs replacing !!!SAFELY!!!

https://www.google.com/search?q=EM-S3553S&oq=EM-S3553S&aqs=chrome..69i57j0.4867j0j8&sourceid=chrome&ie=UTF-8

Sanyo EM-P672W Microwave Oven Repair Questions ...

www.fixya.com > Forum > Microwave Ovens > Sanyo
Recent Sanyo EM-P672W Microwave Oven questions, problems & answers. ... Mysanyo super shower microwave wave stopped working it shows on the display to press clock key but ... What would cause my Sanyo Microwave to not heat up?

Sanyo EM-P672W Microwave Oven Sanyo microwave fuse ...

I would replace it with a fuse of the same 5kv.09 as replacing with another may overload the microwave and cause a fire.

not recommended to replace with a higher fuse rating or kind

follow this steps and fix it. God bless you

1. Inspect the power cordUnplug the power cord and check for voltage at the outlet. Also inspect for damage, shorts, or burn marks that can be a possible safety hazard.
   
2. Bad door switchIf your microwave does not work at all and you know everything is plugged in properly and the outlet is functioning, then also check the door hooks and the door release button. Using a volt-ohm meter on RX1, check your terminals. When your microwave door is closed you should have a reading of zero. Once the door is open the reading should change to infinity. If these readings do not match up, replacement of the door switch is necessary.
   
3. Blown fusesTo determine if your fuse has blown out, which may attribute to your microwave not running, you need to pull the fuse out using a pair of fuse pullers. Lay it down and using a volt-ohm meter on RX1, check both ends of the fuse in question. If you do not get a reading of zero, then you will need to replace the fuse.
   
4. Bad fan motorLocate the fan and remove the leads. Again using the volt-ohm meter on RX1, check the terminals. If an infinity reading is displayed, it means that the fan has gone bad and requires replacement.
   

Here it is
http://eu.sanyo.com/AssetBrowser/Technical%20Database/Instruction%20Manuals/Microwave%20Ovens/EM-S3553.pdf

It does have a line fuse. This link should help you identify the location and replacement. http://www.appliancepartspros.com/partsearch/model.aspx?model_id=208280. Hope this helps you.

Fuse blown? Needs to make high voltage for the magnetron. A blown fuse usually means trouble in the high voltage system (a shorted HV diode or maybe a bad stirrer [metal fan-like device] bearing which is located just above the interior case under the waveguide assembly). If suspect, replace the stirrer as a unit. If fuse looks ok, maybe bad door interlock switch or not being operated by door closure.

you need to replace the magnatron assy and also to be sure the high voltage fuse. good luck.

Sanyo website has all user manuals for download

try replacing the fuse.there might just be a voltage fluctuation in your locality