A fuse blew, now my machine makes a clunking noise thro cycle before bumping its water content out of the soap tray and door. and the green light to open door doesnt seem to go out

take lid off and put mechine on wash look out under soap despencer drawer for water to start with then get back

is it the tub that clunks?was it very noisy in the spin cycle?if so the spider gear is gone and it would be cheaper to replace the washer.you should only be adding two tablespoons of soap that's it,alot of people use to much soap and it eats at the spider gear,if you look inside the tub at the back wall you'll see a piece sign,that's the gear located on the back of the tub

are the filters clean

Sounds lik the filter is blocked its located within sump hose...

has the water spun out if not drain by hand and check pump and filter

You are lucky the machine is not dumping you!

Never but never just replace a fuse without properly finding the cause. Get a qualified tech to check it out for your own safety and peace of mind.

Perhaps you are putting to much in it, poor machine, give it a break in its old age! All the Best -the Yeti PS leave room for the water!

Is there a humming sound? Check you have the hot and cold water supply turned on. Check the water inlet hoses are not kinked.

You cld try 3 things:
1 Find the button on your panel which has the 'key' symbol, press and hold this down till the lock light goes off.

2 Hold down 'options' & 'select' buttons together till the light goes off.

3 Press 'end of cycle' button for 3 seconds, lock should come off.

Pl post back results. Rate if helped.

you may be using too much detergent, or you have a blockage in the outlet.try putting it on to spin to drain out the water, if it does not drain then check the filter or sump hose for a blockage