My whirlpool generation 2000+ oven it says f03 what does this mean

Possibly old FIXYA question has information to assist:

http://www.fixya.com/support/t3893503-display_reads_code_f03_whirlpool_oven

Why is my Whirlpool stove displaying F03 ShopYourWay

http://www.shopyourway.com/questions/1008242 Why is my Whirlpool stove displaying F03 ShopYourWay

What is the question ? Is it about a F03 error code ?

Whirlpool Oven AKZ430 goes to F03 mode in couple of minutes even after...

Have you tried to reset it ?
If yet then I may be reprogrammed:

Whirlpool Oven AKZ430 goes to F03 mode in couple of minutes even after...

Hi

Code F03 usually means that the oven temperature sensor is 'open circuit', that is not working at all.

The remedy is to have it replaced.

Needs programming sometimes they leave the factory without it or they can lose the programme.

Hi


Thanks for using FixYa. F3 error means Open oven temperature sensor or thermal fuse. You’ll need to replace oven temperature sensor or thermal fuse to resolve the issue.


Please do accept the solution if the issue is resolved or else revert for further assistance.


Thanks
Rylee

I bought a new oven found this one way to complex anyway. Afterall i just want to cook in it.

Regards

Ken Mc

On this model, F03 indicates a faulty power control board (also known as the "Capricorn" board by Whirlpool technicians). A new oven with no guarantee? There is usually a reason something has no guarantee, in your case, a faulty control board. It is a relatively expensive part unfortunately.
You can try disconnecting from power, removing top panel from oven. The large square electronic board you see on the top of oven is the power control board. Check all plug connections are OK, especially the large thin multi plug that goes to the display board- I have had a poor connection at this plug causes F03 faults. If still no go, power control board will need replacing

f03 error is a sensor error.you could have taken an ohm reading on the thermistor to see if it was bad.if you replaces the t-mistor then the only other component responsible is the board.make sure all the connections on the board are clean and tight before you replace it.