Girlie - Cannot set combi boiler timer

Is it electric? Do You have power? Is the temperature setting on high setting?

If you they won't go off when your timer is off. There's a possibility it's clock keeping it on although its turned off, which is fairly rare. However depending in which model of Vaillant you have, if your boiler has a hot water pre-heat on it. Some models which have this the diverter was prone for sticking thus leaving the port for the radiators open when in hot water mode.

How do I set the timer on my Ariston E-Combi gas boiler

english -
http://www.acwilgar.co.uk/Boiler-Manual-PDF/Vaillant/Combi%20compact%20and%20thermocompact%20logical%20fault%20finding.pdf



russian -
http://www.vaillant.ua/stepone2/data/downloads/cd/33/00/IA_VC_182E_VC_242E_Scan.pdf

Check out the vaillant web site Or talk to there hotline people .

LOOK ON ONE OF THE COVERS 75% OF ALL CODES ARE ON THE INSIDE OF A COVER FOR SERVICE TECHS, NOT MUCH HELP BUT HOPE IT LEADS YOU DOWN THE RIGHT PATH

Hi ,

Can you please tell me the model of the vaillant, and the approx age?

I can solve this problem

I await your reply

Thanks

Steve :)

on the pipework below there may be a silver braided hose with one or two valves on the end. turn the valve(s) so the handle is inline with the pipe this will allow water from the mains supply into the heating circuit , remember to keep an eye on the pressure gauge. fill the system to 1bar cold then shut down the valve(s). turn on the boiler and it should be ok, if you lose pressure again then you may have a leak somewhere which needs to be found.

check to see the time clock is set with the clock symbol. there are three settings on analog clocks I , O and clock the I setting is constant running, the O setting is off and the clock setting is timer.
also try setting the thermostat up higher to see if the boiler fires.

when the tap is turned on and the water light on the boiler doesn't this means the diverter valve is not operating it could be down to low water pressure in the house this can be checked at the cold tap in the kitchen. if there is plenty of pressure then it could be the diagphram in the diverter valve is worn or split. the diagphram is only a few pounds but it depends on the engineer you get as to how much money he wants to fit it.
the egg timer symbol (or two pyramids together) is an ignition indicator turn off and on again to see if it will fire with the tap running. reset the boiler with the lower right hand control knob.