My camera lens does not open correctly. All pictures are over exposed and look white with lines. The video mode is working fine though?
SOURCE: Camera powers down after lens comes out
Contact Fuji re this. if under warranty it will be replaced.
If out of warranty they may offer a discount on a replacement
SOURCE: When my camera comes on, the LCD screen is black. It's like the
CCD FAILURE !!!
Good news is u can always askfor free CCD replacement from FUJI i got it for S5000 even it was outof warranty and was not on service advisory list u have to call and askthem or email in ur region see the link for the problem
http://www.imaging-resource.com/badccds.html
if u are in U.S just dial this number
+18008003854
or just go to www.fujifilm.com and go to ur region link for support i am sure they will do it FREE OF COST !!
pls rate me FIXYA for help
SOURCE: Pictures are over exposed ( white ) in any mode.
CCD FAILURE !!! it starts with overexposed pics and purple and pink shaded pics dont worry
Good news is u can always ask for free CCD
replacement from FUJI i got it for S5000 even it was outof warranty and
was not on service advisory list u have to call and askthem or email in
ur region see the link for the problem
http://www.imaging-resource.com/badccds.html
if u are in U.S just dial this number
+18008003854
or just go to www.fujifilm.com and go to ur region link for support i am sure they will do it FREE OF COST !!
pls rate me FIXYA for help
SOURCE: Fuji Fine Pix s5000-Horizontal lines with purple coloring mixed
not a software issue it is
CCD FAILURE !
CALL Fujifilm they will do it FREE it is a known problem in thousands
of camera i got my S5000 with same problem repaired FREE from FUJI just
call them
BAD CCD
RATE ME WELL !
SOURCE: whiteout on fujifilm f20. how do I remove the lens?
Firstly, to isolate the shutter as the problem, turn the camera on and the flash off. put the lens into full optical (not digital) zoom. Then turn the camera lens to face you and look at the lens and take a picture.
With the camera in full optical zoom the shutter assembly will be right up to the outer lens so you can see it clearly. When the button is pressed you should see the shutter fire across the lens inside. It should cover the lens completely. If it does not or doesn't fire at all then you get over exposed pictures or lines across the photo. The most likely cause for this is moisture residue on the shutter leafs sticking them together.
To clean you will need to strip the lens down almost completely to access the shutter assembly. If this model of camera uses a sealed shutter unit then it will be impossible to clean. The only models i have found so far that use a sealed unit are the F460 and F470. Yours I am not sure of as I haven't opened 1 up but the solution for most is to strip it down and clean.
Tip: use another camera to photograph each stage to help on re assembly
100 views
Usually answered in minutes!
×