How do I fit a new door latch to a Bosch Classic Maxx 1200

i will need the model number should be on sticker on the inside of the door

Yes but there are different colour choices

Door not detected closed
Check door is closed
Check door catch and latch
Check door lock

http://www.appliancepartspros.com/bosch-washer-parts.html

Could be the Door interlock Not too expensive to buy simple to fit

you cannot you can try manually turning switch so it does its last rinse and spin and weight untill light goes off there is a switch inside the m/c when the water gets to a sertain level the door will not open for obvious reasons hope this helps ivan uk

http://www.bosch-home.co.uk/customer-service/download-product-manuals.htmlYou will need to enter the Enr number from the rating plate ( on the inner door trim) use the link, click on Click here to download product instruction manuals. This will open a new window where you can enter your machine model. IU is user info..II is installation info

how to clean the rubber around the door of front loader gets black dirt

Power on, press the start button for 5 or 6 seconds, the sign will go off. Try the door gently.

Sure we know how to unlock it, but rate me 'very helpful' for the free help, thanks

To change the seal the easiest way is to take the front of the appliance off. Remove the kick plate at bottom and you will see some screws holding the front panel on remove these Then open door and remove the screws holding the door lock on and unlip the seal by releasing the clamp on the front. The front should now lift off, if it doesnt then pull out the soap drawer and behind that at the bottom of the drawer is a screw holding the front on remove this then push the front panel down then it will lift off You can now take the clamp holding the seal to the tub off. Fit the new seal, fit the clamp to the seal and tub. From here, rebuilding is the reverse of the strip down.