Zanussi ZT685 My Dishwasher is not emptying completley

C8 - During rinse phase boiler doesn't empty:

• Rinse pump not efficient.
• Rinse arms obstructed.

• Boiler level sensor out of order.

Dado

check the drain filter is not blocked if it does not empty all the water it saves time on the next fill. also the spin will not happen if it has not emptied completley. a faulty pump would give the same effect.

Hi,

Here is a tip that I wrote that will help you with your dishwasher not draining problem...

Dishwasher Problems - Water will not drain out

heatman101

The machine goes on and makes the usual noises but no water is coming in. The water is on and the hose is fine. It is ZT685

The outlet pump is triggered by the anti flood micro switch via the polystyreene float on the base of the washer. If any water for whatever reason (leaky pipe)is on the floor the machiene automatically switches to pump out mode and only works once the water and the cause is rectified

hi There - We have exactly the same problem which you describe, and wondered if you had managed to find a solution.

Just had this problem, I have a temp set up and found the drain was a bit to high. Put a bucket of water in to the machine and lowered the hose. It went through its cycle and emptied. now works OK, seems that it needed to empty to re-setrt the cycle. Worth a try

You can get the manual here. You will need to know the model # though. I looked at the first manual and it will show you how to fill the salt.
http://www.usersmanualguide.com/zanussi/dishwasher

Good Luck and please Rate FixYa!

door not closing properly can you hear door click? problem with door switch

Zanussi Aquapulse dishwasher - is filled with water inside, is not washing and the lights keep flashing on and off - has anyone any idea what may be wrong with it?