How to remove door for whirlpool oven RBS305PDB2

Sounds like a bad oven control board which is the control you are trying to set.

I am not sure about this, but sounds like a connector is on backwards or in the wrong place.

A new membrane switch is required. Although they have been discontinued by the original manufacturer, replacement units are available here:

E1 F2 is due to a touchpad failure (part numbers: 831541 831543 831544 831545 831546 904520 904521 960314 960315 4451349 4451350 4451351 4451352 4452705 4452706 4452844 4452845 4456309 4456311 4456312 8300449 8300450 8300453 8300454 8300455 8300456 8300457 8300515 8300529 83005324451230 4451324 4451330 4450711 4451231 4451232 4451233 4451327 4451328 4451333 4451334 4451336 4451337 4451339 4451340 4451341 4451342 4451343 4451345 4451346 4451347 4451348 4452857 8300460
Introducing the Ledgestone Technologies Touchpad

Models: RBS305PDB1 RBS305PDB2 RBS305PDB4 RBS305PDB6 RBS305PDQ1 RBS305PDQ2 RBS305PDQ4 RBS305PDQ6 RBS305PDZ1 RBS305PDZ2 RBS305PDZ4 RBS305PDZ6RBS305PDB10 RBS305PDB11 RBS305PDB12 RBS305PDB13 RBS305PDB17 RBS305PDB8 RBS305PDB9 RBS305PDQ10 RBS305PDQ11 RBS305PDQ12 RBS305PDQ13 RBS305PDQ14 RBS305PDQ16 RBS305PDQ17 RBS305PDQ8 RBS305PDQ9 RBS305PDS12 RBS305PDS14 RBS305PDS16 RBS305PDT10 RBS305PDT11 RBS305PDT12 RBS305PDT13 RBS305PDT14 RBS305PDT16 RBS305PDT17 RBS305PDT8 RBS305PDT9 RBS305PDZ10 RBS305PDZ8 RBS305PDZ9

500 degrees farenheit is 260 degrees celcius (metric)
any chance the display is set for metric ?

hi there sometimes glass will just pull up on sliders on the side just open door etc and the glass panel should simply slide up.

As there are too many variations to describe on fitting and removing oven door hinges, try this link.

WWW.YOUTUBE.COM.
Then in the search box, type in,---Fitting oven door hinges.
You should be able to find the ionformation you requre here.
Hope this helps.

I removed the oven door without putting in the door removal pins that I was supposed to use. Now I can't put the door back on.

after cleaning the oven the bake temp would not go any higher than 350. when you press the temp button to go lower or higher it only go down. could you tell me what is wrong or what to do.