I have model 8410D. The speaker light keeps flashing. I tries the Shift button & pressed the speaker button, no luck. Any other ideas?

its likely your key is bouncing an needs cleaned or replaced . use a diffrent phone to be certain

TO SHIFT FROM km/h TO mp/h: HOLD DOWN THE «MODE» AND «CLOCK» BUTTONS SIMULTANEOUSLY, WITH THE KEY SET TO «OFF». THEN TURN THE KEY TO «ON» HOLDING DOWN BOTH BUTTONS FOR MORE THAN 3 SECONDS. WHEN THE WORD «SET» IS DISPLAYED THE UNIT OF MEASUREMENT HAS BEEN CHANGED
http://manuals.wotmeworry.org.uk/Gilera%20Nexus/Nexus%20300/Nexus%20300%20Owners%20Manual.pdf

Did you try pressing the CDC eject button and keep pressing it until it ejects the CDC Box?

You can not. It needs to be done from the command line at the admin console.

I have no idea about the model number of your appliance, however, the error "Rinse Only" light flashing, indicates that the keypad interface is bad and needs to be replaced.

As the dishwasher detects there is a key pressed and stays pressed, it shows this error. You may want to try pressing each button of the dishwasher to see if by chance it is released.

After some years of use, it's normal that the keypad needs to be replaced because the wear & tear.

Good luck.

Hi Guys
I had the same problem with all lights flashing nothing working, happened after a panic power shut down. As with peter after the paper button was released, printer lit up like a christmas tree again. I played around with the button combinations and found that holding down the ink button instead of the flashing paper button cleared the problem. Great tip guys saved me a lot of money. cheers me dears clive.

not sure if this site will help or not as I don't have this phone system, but maybe you can make sense of it.
Best of luck.
http://www.tek-tips.com/viewthread.cfm?qid=1587630

try a #20 amp fuse

1. Turn off printer
2. Hold down Resume button and press Power button.
3. Keep holding down Power button and let Resume button go.
4. Press Resume button 2 times then let BOTH buttons go.
5. Green lights will flash and then stop blinking.
6. When green lights are solid, press the Resume button 4 times.
7. Press the Power button and the printer should turn off, if not,
press the Power button once more.
8. Your printer should respond as normal..

The overflow container underneath needs to be emptied.

heres a discussion about the problem
http://forums.partselect.com/dishwasher-repair/eco-light-flashing-dishlex-global-300-a-7664.html

Hope that solves it.
Ekse