Installed new tub faucet and all i have is a trickle

Possible wired neg to pos and pos to negative.

check the circut breakers too.

Blocked inside the tap on hot waterside could be some packing in there

As you want to remodel your bathroom it is a great way to add value to your home. The first thing you have to do is to plan about a bathroom remodel structure and also get in contact with the plumbing suppliers. My cousin has remodeled his bathroom, he had chosen the lighting that will compliment the natural lights of his bathroom. He had also installed a shower and a walk-in bathtub by hiring a reputable general contractor for a walk in bathtubs Renton, and selecting the one best model that suits his bathroom decor. After the remodeling, it increases the enjoyment of one of the most used rooms in his house.

Sound like a diverter, just take the faucet back to where you bought it and get another one or another brand, take care and good luck.

Hi, If you asked me, I bought from amazon/ebay depending on reviews... (that way you cant buy something not good). so.. take look Were doing more than just throwing away the key . I hope this helped you. Cheers

No warrantee on new home?

No instructions left for ALL fixtures,water heater,heating system etc that where installed???

Go to a plumbing supply store,and see if they can help. Not Home Depot

you need to have both done before any judgement is made, the balancing spool could be off centre because of only one water being hooked up. good luck

When you installed the new tub faucet you probably turned off the water to that faucet of even the whole house. IF IT IS AN OLDER HOUSE, TURNING THE WATER OFF AND BACK ON CAN LOOSEN SOME DEBRIS IN THE WATER LINES THAT CAN FIND THEIR WAY TO YOUR NEW FAUCET. If there is a screen at the end of the water outlet it can be clogged with gunk. Uncrew the screen on the water outlet and clean. You may also want to flush out the hot and cold outlets by turning the water off, removing the cartigages and slowly let water flush them out. Then reassemble. Also when you have the tub handles out you can turn the hot and cold supply valves off and on a few times to loosen more debris if it exsists........Joe

Hi rbyerly,

I'm Harvey the Master Plumber.

Your problem is:
remodeled bathroom,installed new moen valve and hardware. Now water is coming from both the shower head and the faucet when the diverter is in the down postion. Question; Is this a single handle or three handle diverter? Assuming it's a three handle, it should just be a mater of adjusting the center handle. If single, the diverter is in the spout not the valve. I don't know how to direct you further without specifics. Feel free contact me again!
Please give me a rating here at fixya.com before you sign off
Thank you,
Harvey your Master Plumber