How to print 11 X 17 documents using a Kyocere CS 2550 printer

umm if I understand correctly you want one document printed same document on both sides select double side printing the where it ask for how many copies you want send to or how many of the documents you want in increments of two ex. 2=1 double side copy,4=2 double sided ,6=3double sided

Sounds as if the drum needs to be replaced if it does this on copies and prints.
If it just happens on copy when using the document feeder then try cleaning the narrow piece of glass that is located just to the left of the large piece of glass.

Try this... Remove all the connection to the PC (USB, network or parallel). Turn off the printer on the power plug for about 3-5 minutes. This will clear all the documents sent previously.

Below is a link to Copystar's website where you can download the CS-2550 print driver.

http://usa.copystar.com/americas/jsp/Kyocera/resource_details.jsp?pid=13704&rid=22655

I hope this is helpful,
Shawn

u can only do it via a network cable and as long as u have all the details correct ip, sub net mask and possibly gateway.or a cross over cable to a single pc

ok... I am tech... and I had the same problem... you need to install the generic postscript driver then goto this ip address (http://localhost:631)and tune the driver... if not you will only print from tray 1 and only a4 paper size...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

change the driver from kpdl to pcl xl, this is normal problem with pdf files. you do this from ur computer driver.

I’m happy to help further over the phone at https://www.6ya.com/expert/mustafa_06f84c65ab5cc745

can't print on something that small

HI there try the following.

• Open Internet Explorer
• Type in the address bar the IP address of the scanner (If you do not know this print out a status page)
• Once you have typed in the IP address you will then have the scanner configuration screen on the left you should have passwords section you will be able to change it from there.

Hope this helps you
Thanks J

Make sure CS is updated and that it actually send jobs to the PRINTER QUEUE.