SOURCE: Battery Recharging
Okay, the same thing happened to me. I ordered a new battery and that was not the problem since the same blinking light was haunting me! So I bought a wall charger for the battery alone and then it worked again on the original docking station. Apparently it will not recognize a completely dead battery on the docking station. It makes no sense but it worked for me. So good luck to you!
SOURCE: set date and time comes up every time i turn on camera
Try resetting your camera. In picture taking mode press menu. Go to setup, go up to reset, press right arrow, make sure reset is highlighted and press set.
Then TAKE OUT MEMORY CARD. Go back into menu, go to setup, go up to format, press right arrow and highlight format, press set. Input ur date and time again and then power off and back on. If that doesn't help then you have to send into repairs. 800-706-2534 and keep choosing option 2 and they will tell you where to send it.
SOURCE: Battery Dont Charge
jpierre's solution (in another thread) was right on the money. Touch
the positive (+)end of the 9v battery to the positive (+) end of the
camera battery.Leave them touching for a few seconds (10 seconds should
be more thansufficient). Seems these lithium-ion batteries are subject
to a'digital memory.' Subjecting it to a volt surge almost three
timeshigher seems to clear it.
http://www.batteryuniversity.com/parttwo-34.htm
In short, it works like a charm.
SOURCE: panasonic SDR H20 camcorder
Hi There, You probably have a blown out fuse. Unless your a service tech with a service manual, it may be hard for you to locate where the fuses are. A panasonic service depot could give you a proper estimate.
Thanks, mr cicmo
2,473 views
Usually answered in minutes!
×