I am getting a DC error on my alpine cde-102 head

Hello Sandra White,

The term "Interrupt" is just a fancy way of saying Mute. Also if you could provide a bit more information as to what his Radio is doing while it says Interrupt that would be great.

Regards,
Roger

Depending on the age of the unit and the vehicle, it should be color coded. So just transfer the wires color for color to the new connector.

I need the code for alpine radio kia logic control
model no : auk-8625

une or more speakers wires are touching ground or is in short...

I also have the same question, can any one help? How do I get the clock to stay on, on the Alpine cde-102?
The moment you switch off the system the clock goes off, even if the car is running.

Press the Rotary encoder (CDE-9845/CDE-9843
only) or press MODE (CDE-9841 only) repeatedly
to choose the desired mode.
Each press changes the modes as follows:
BASS → TREBLE → SUBWOOFER* → BALANCE → FADER
→ DEFEAT → VOLUME → BASS
BASS: -7 ~ +10
TREBLE: -7 ~ +7
Subwoofer : 0 ~ +15
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35

Hello desoren,

The receiver may not be set to recognize MP3 files.

Press and hold "sound setup" until the unit enters setup mode. Rotate the volume knob to "play mode" and press "enter". Check that the setting is CD/MP3 (not CD/MA), or rotate the volume knob to change the setting to CD/MP3 and press enter again. Press and hold "sound setup" again until the unit exits sound setup.

If the files are still not recognized, I'd try using a different USB drive, a different computer to write the MP3's, and/or a different application to download or rip the original music content.

Hope this helps.

Hello eklypss2000,

According to the manual for the Alpine CDE-102, the message "DC ERROR" is displayed if there is a short to ground in the speaker wiring. Check all of your speaker wires and make sure that no bare wire is shorting against the vehicle metal or against other wires. Repair or replace the wire as necessary. After correcting the problem, set POWER IC to "POW ON" according to the instructions in your manual.

Hope this helps.

they are blown, either have them fixed or buy another head unit or the best way is to just use the RCA outputs from the head unit

Have one solution which might work.
Remove head display unit and press reset dutton usins a pin.
now connect head display unit. now insert CD. make sure the CD is in good shape.

Cheers
Alex Victor