HOW DO YOU RESET THE CLOCK ON A WHIRLPOOL WALL OVEN-- MODEL #WOS51EC7HS?

You may have a damaged oven control panel. Contact your local utility and file a damage claim

https://www.partselect.com/Models/FEB754BBBA/


My FEB754BBBA Model Overview from PartSelect com


Unsure if the knob shown would help or not.

that isn't a model number,if you look at the touch panel does it say clock anywhere on it?if so touch it and it will tell you what to do.what happened to the clock did you lose power? if so the computer board could have been damaged,send the model number off of the wall oven.when you find it google it and you should find a manual for it online or utube

The model number is usually located on the side of the door or on side of the oven cavity area near the door opening. Sometimes if you have a drawer or warmer the model number is located on the oven side of the drawer or warmer (sometimes not directly facing you but on the side of that area. If the oven is electronic you press a clock button or you hold one of those buttons for a couple of seconds like a start or set button. The model number though will help you find a user manual and it for sure should be clear. I hope this helps you.

Previous fault F02 is indicating an overheat fault- service manual says to replace main electronic control board. However, switching off at wall has reset the clock- you need to set the time before the oven will work-press middle button until small triangle is next to clock icon, set time using temperature dial. Once clock has ben set, try using oven to see if F02 fault reappears- sometimes switching off at wall will clear fault. Good luck!!

Ouch...sounds like the control module is blown. Thats the electronic timer. I've known this happen on several occasions. Bad luck!

your fuses in the oven are bad it might have a fuse or a reset thermostat i need your model to tell you where to check and also make sure you have correct amount voltage in the wall outlet if its electric oven than you need 110 volts on each leg if its a gas oven than you need just 110 volts on one leg

You may set the clock on your Microwave per page 6 of the User Guide by following the steps below. We've included the link for the User Guide below.https://www.whirlpool.com/content/dam/global/documents/200105/owners-manual-8300610.pdf

This is a 12 hour clock and does not show a.m. or p.m. To Set: Before setting, make sure the oven, Timer and Timed Cooking are off. 1. Press CLOCK. 2. Press the HR or MIN "up" or "down" arrow pads to set the time of day. 3. Press CLOCK or START/ENTER. To Disable: The clock time can be disabled so that it does not show on the display. To disable, press and hold CLOCK for 5 seconds. To display the clock time again, press and hold CLOCK for 5 seconds and the time of day will show on the display. The clock time should not have to be reset.

you need a new fuse it is not resetable should use renches but be carful if not comfortable call service

It is likely the Thermal Cut-Off (TCO) fuse, which for many Whirlpool ovens is located on the back of the unit. Turn the circuit breaker for the oven OFF first. You'll need to remove the trim on the left and right side of the oven (2 screws) and then remove the screws holding the oven in the wall. You can locate it easy enough by looking for the thermal fuse on any of the major appliance part websites. The test is simple enough if you have an Ohm meter, as it will be an open circuit if it is blown. There is only one fuse (normally) so if it is blown neither the bake or broil element will work. There should be a Tech Sheet located behind the control panel which will help, but if you don't feel comfortable doing this call a service tech.