GE dishwasher heating element will NOT turn off. Even after breaker reset.

SOURCE: GE Max dishwasher no lights on panel

I have the same problem and actually found a workaround by mistake you may try as a temporary solution (if that works for you):

- press and hold the lock button for a couple of seconds
(the delay timer would increase by 1 hour)
- press and hold the lock button again
- repeat until it reaches 9hrs
- repeat one more time: the control panel should be functionnal again.

Let me know if that worked for you!

SOURCE: electric hot water heater 40 gallon ge

Typical H2O heater with 4500 watt elements should draw around 18 amps. Check to make sure the connections for the wires at the breaker are tight, loose connections will cause the breaker to heat up. If all of this is good and the breaker is still heating up, it is time for a new breaker.

SOURCE: Maytag MDBH970AWS Heating element won't turn off

The heater relay is located on the control board, a faulty relay or a faulty control board would cause the problem you have described. The fix is to replace the control board. Parts for your unit should be available from most appliance parts retailers, if there is not one local to you, the part is available at www.apliancepartspro.com. along with an exploded view of your unit

Hope this helps.

please take the time to rate this solution

SOURCE: my GE triton dishwasher has water standing in the

The GE GSD5500 has a check valve in the rear of the unit under the FILTER FRAME that screws in. GE part WD24X10018.
The white rubber stopper wears out and lets water return to the tub!
Remove filter frame (4 screws) and unscrew the check valve to replace. Try appliancepartspros.com for part # AP2617344.

SOURCE: GE Profile Dishwasher beeping

Mine was doing the same thing. It was eligible for a recall.
Free repair or rebate toward new purchase. 1-877-275-6840 or go to website geappliances.com