My dishwasher AEG FAVORIT keeps beebing and not working it flashes with a arrow and stright line? it stoppted half way through

If your AEG FAVORIT 35085 Vi dishwasher beeps five times and stops halfway through a wash cycle, there could be a few potential causes for this issue. One possibility is that there is a problem with the water supply, such as a clogged or partially blocked inlet valve. Another potential issue could be related to the drainage system, such as a clogged filter or a malfunctioning drain pump. It's also worth checking if the dishwasher's spray arms are spinning freely and not obstructed by any debris. If the problem persists, it is recommended to consult the dishwasher's manual or contact AEG's customer support for further assistance. They can provide specific troubleshooting steps and guidance based on your dishwasher's model and any error codes that may be displayed.

http://www.usersmanualguide.com/aeg/dishwasher/favorit_525_u

https://www.manualslib.com/manual/44456/Aeg-Favorit-Compact-525i.html



AEG Favorit Compact 525i Operating Instructions Manual

Please, follow this link:

http://www.manualslib.com/manual/541167/Aeg-Favorit-625-I.html


Dado

the door latch is broken have it replaced

Hi,
Check your heating element..

Dishwasher Problems The Heating Element not Working
http://www.fixya.com/support/r4589033-dishwasher_problems_heating_element_not

Dishwasher Maintenance
http://www.fixya.com/support/r4319937-dishwasher_maintenance

heatman101

Looks like what you need is available at

http://www.serviceforce.co.uk/pdfs/U20206.pdf

Good luck with the new house. Hope the dishwasher works well for you.

Try to run it with dishwasher cleaning kit (no utensils) to make sure everything is clean - that way you will get more life out of it. The cleaning kit (usually Finish) is sold in the supermarket in the detergent section.

Buy a new one. Whirlpool, Kenmore,or MayTag

If for any reason (water leak)the anti flood device at the bottom of the washer is triggered it automatically stops the inlet of water via inlet solinoid and puts the washer in pump out mode. Check the float (polystireene plate with micro switch at the bottom of the washer). Dry any water and determine the reason for water and this should let water in again.

This seems like the anti flood system (polystireen float / micro switch) at the base of the washer is triggered,\. This puts the washer in pump out mode and stops inlet of water via the inlet solinoid. Dry the water on the base and then check for any water leaks. (pipe leak

The dishwasers have heat (inductive) elements in line with the top sprayer hose and is about +/- 15 cm long and has an electrical push on clip at the side of the device.