Were Can Find The Model Number On GE Commercial Quality Top Load Washing Machine ?

SOURCE: Cannot find the model number

If this was a scratch and dent model, model number may have been removed prior to sale. If not, you should find it on the back edge of the washer at the very top as you look over the back of the machine. If you can't find a model number, bring the part(s) you need to a servicer. They may be common parts or there may be some identifying numbers on the parts themselves. Good luck.

SOURCE: ge washing machine top load model wlsr3000 will

grab agitator and **** up. Remove metric bolt and coupling. Tighten large nut to the left

SOURCE: I own a GE Commercial Quality 3 Wash Spin

Hi, if your washer pumps out the water but doesn't spin, check these:

• The lid switch may be defective. If it is, the washing machine doesn't spin. The switch is inside the washing machine main housing near the door frame. Often you have to raise or open the top or front of the washing machine to get to the switch. If it's defective, you need to replace it.
• The motor coupler may be broken. Many Whirlpool®-manufactured washers use a small, relatively inexpensive motor coupling. It's plastic and rubber and is mounted to the shaft of the motor on one side, and to the transmission on the other. Over time, the coupler wears out and fails. You may need to replace it.
• A belt may be broken. Many washing machines have one or two belts. If a belt is broken or badly worn, you need to replace it with a genuine belt from the manufacturer. (Some washing machine belts are designed with special characteristics not found in automotive belts.)
• The clutch may be worn. If your washer is a GE, it may use a clutch to come up to the proper spin speed. As the clutch wears out, it may prevent the unit from spinning well or at all. If the clutch is worn, you need to replace it. For this job, you probably want to hire a qualified appliance repair technician.
• The drive motor may be defective. Many washer brands use a reversing motor. For agitation the motor runs in one direction, for spinning and draining, the other. It's possible for a motor to burn out in one direction and continue to operate in the other. If this happens, you need to replace the entire motor.
• The spin bearing or basket drive may be worn or seized. These components allow the inner tub to spin freely inside the outer tub. When this is the problem, you usually hear a loud sound during the spin cycle. Call a qualified appliance repair technician.

Richard Roth

• 9472 Answers
• Posted on Jan 05, 2011

SOURCE: NEED TO REPLACE THE BELT

Here is a video to help you with your washer belt problem.

SOURCE: washing machine does not stop

The water fill valve (the plastic thing that the hot and cold hoses go to) has an obstruction (piece of rust or minerals from the plumbing) and the valve won't fully close. A speck in the right place is enough to cause overfilling.

or

The water level switch is defective.

or

The tubing that is attached to the level switch is loose or off. This hose must be tight on the fittings.