I have an old GE universal remote model RC24991-C. I'm looking for the programming codes to set it up with a Phillips DVD player model DVP1013. The instruction book for the remote is online but it doesn't contain the codes. Any help would be appreciated. Thanks.

Note: most remotes allow you to find the code by manually turning the TV (or other device) on first, then press the appropriate button (cable, DVD, surround, etc) then setting the the remote in the "program" mode, then keep pushing the "off/power" button until the TV (or other device) turns off, at that point the code is set.

Look on here:
http://www.comcast.com/Media/1-2/CM/VanityURL/documents/comcast_on_demand_remote_manual.pdf

I doubt the Ge will even program for that set---Google both the model number of the remote and the set to locate the available information.

Need Code for GE RC24991-B Remote Control

I have Hitachi universal remote CLU - 5729TSI how can I Program it to change the code for a different tv. a toshiba 36 inch it is around a 1999-2000 model.

You can find the codes here

http://www.jascoproducts.com/support/universal-remote-codes.asp

I have a GE Universal Remove (RC24991-b), and the code I got to successfully work with the Memorex MVD2042 DVD Player is 0446

For the GE Universal Remote (RC24991-b), 0157 works (for me) with this Durabrand model

To make it multiregion, follow these steps:

Press "Setup" button on remote.
Scroll to "Preferences" using the LEFT/RIGHT arrow key.
Press "138931" and a pop-up screen will appear.
Use the UP/DOWN arrow key to choose the desired number.

You can select a specific region (1 through 6) or region "0" for all regions.

I just bought a 32" dynex lcd and saw that i couldn't program my two $5 ge remotes to work it. From reading in this forum and others I'm not the only one with the problem, I thought I was stuck with only the dynex remote. But the dynex website tells you how to get universal remotes to work,
It tells you to try the codes for Orion, Emerson, Memorex, Sansui, Sylvania, Zenith. The second orion code worked for me. both my ge remotes look and work the same but one uses a four digit code and the other uses a three digit code. I used 0135 on one and 135 on the other. There is a good chance that if you try the codes for the brands dynex lists you will find one that works. The 0135 or 135 might work for most dynex tv's.
If you have a ge remote and haven't programmed it for volume punch through you might try it. It allows the tv volume to be controlled using the ge remote even when it's set to something other than tv.