BTW. I tested the thermostat at room temp it has continuity, it opens [no continuity] @ 275
Check if both legs of your 220 volt outlet are hot. Check the power cord at the dryer-carefully.
Testimonial: "Thank you, I checked both fuses at the panel and they are ok, what I did find is one leg on the plug appears to be burned. No idea why. I will check continuity on power cord for all 4 positions, maybe I need a new cord.I have a pic of it,but, don't know how to post."
SOURCE: Whirlpool duet electric wil not heat
Remove 1 wire from the element . Your 220 V comes from ...110 motor , 110 control board . Check which wire is not getting 110 V , trace it and see which it comes from . That will tell you which one is defective .
SOURCE: Replacing a heating element on Maytag Electric Dryer
Hank,
if you have all those parts , i would indeed replace them all. it will allow your entire heating circuit to strat fresh
just ensure all your paddle connections are tight
but check your heater for continuity too
Testimonial: "Thanks, I'll replace everything! "
SOURCE: eden pure heater starts to heat then elements shut
yes u have overheatsensors that shut the strips down if they get too hot these may be going bad and getting weak and shutting off prematurely
SOURCE: Kemore dryer model110.67522600,
Both the high limit thermostat #3977767 and the operating thermostat #3387134 are normally closed switches and should have continuity. These thermostats are usually replaced as a set because when one fails its often caused damage to the other. The part # for the kit is 279816 and comes with both and is cheaper than if bought separate
SOURCE: I have a Whirlpool Dryer
Hi, If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat. check out this electric no heat tip... heatman101
322 views
Usually answered in minutes!
×