How do i clear all channels and start over putting in new ones

hello You can unlock all locked out channels in any bank at one time. To do this, first press a bank key to start scanning. Then press [HOLD] to stop scanning. Press and hold down [L/O] ("L/O" appears on the screen) for more than 2.5 seconds until you hear the multi-beep ("L/O" disappears). Now all locked out channels in the bank are unlocked and restored for scanning hope this helps you cheers

hello first press bank 1 ,press pgm key enter frequency and then enter when you have the bank 1 full start bank 2 etc goodluck

Program 000.0000 into the channel, then press PRO...CH. UP or DOWN.....hope this was helpful....

http://www.uniden.com/pdf/BC350Com.pdf

Here's your manual. Page 31 explains how to unlock a programmed channel, hope this helps.

There is no need to clear the scanner before reprogramming. When you enter a new frequency it will automatically overwrite the old frequency. To clear unwanted frequencies you can program "0.0" into any channel to clear it, or simply use the LOCKOUT feature to prevent the scanner from stopping on a channel.

There are several ways to program your scanner, so the best thing for you to do is review the owner's manual for your scanner. You can view/download/print your scanner manual at:

http://uniden.com/pdf/BC350Aom.pdf

I couldn't find the "A" but here's a link to the manual for the BC350C. Hopefully it will help.

http://uniden.com/pdf/BC350Com.pdf

There is no global clear/erase function on the BC350C, but programming a new frequency on a channel automatically deletes/erases the old frequency. To delete an inactive or troublesome frequency, program "000.0" in that channel. Doing so will deleted the previously programmed frequency and set the LOCKOUT to ON for that channel. For more information on deleting frequencies, see page 27 of your operating manual.

Need the manual? You can download it here:

http://www.uniden.com/pdf/BC350Com.pdf

If your scanner is the BC350C (the section you posted in), here's a link to the owner's manual which will give you detailed programming information:

http://www.uniden.com/pdf/BC350Com.pdf

If you have a different model Bearcat scanner, try:

1. Push MANUAL to stop scanning and advance to the channel that you want to program.

2. Enter the desired frequency, including the decimal point (e.g., 156.015).

3. Press E or ENTER to set the frequency.

4. Repeat the process, starting with 1 above to select the channel.

NOTE: With some Bearcat scanners you may need to press the E or ENTER key before entering your frequency.

These are general steps that work on most recent Bearcat models. If they don't work on yours, try different variations. You can also check Uniden.com -- they may have an online manual that you can download and print.

Your scanner does not do trunking. However, you should be able to monitor Dallas PD using it, since they are not using a trunked system. Richardson PD is using a EDACS system, which is trunked. You may still be able to pick up the frequencies used by Richardson, but the PD channels will be mixed in with all other users of the system.