Hoover Dynamic Next washer dryer.start button won't work on 59 minute programme but works on other programmes. The "delay start" has not been activated.

SOURCE: WD440 programme m

This sounds like a faulty pcb and/or inlet valve. see links for prices.

meatballs77 - If you have warranty (the machine is less than 1 year old which yours is) or paid for extended cover then call hotpoint to replace... Hotpoint should be able to fix this - this should be free. call 0870 4422 510

Rememer parts are free up to five years - but there is a £90 callout fee after the first year.(unless you extend the full warranty)

SOURCE: my washer wont choose a programme

push start buttons more than 10 second

SOURCE: my indesit washer/dryer model w10

probably a main module fault but worth while checking for continuity thro the heater and that the pump and filter are ok. the idea is that when a fault is detected, the dial will click round indicating a fault but usually it is the module itself. expensive part. not worth repair

SOURCE: I have a Hoover Washer

11 LED flashes indicates either a wiring fault or I'm afraid the main board has gone (Hoover Engineer required).

Richard Roth

• 9472 Answers
• Posted on Nov 03, 2012

SOURCE: Hoover washer dryer Error Code E12 during dry programme. How can I fix?

E12 means a problem filling on dry cycle.

Unplug the appliance, take the top off and check that the plastic condenser below the fan is clear and clean.

If this is ok, the most likely fault is the triple valve isn't opening properly to feed water into the condenser.