Its a service error.that printer needs servicing or any of the internal part of the printer is got loose or moved from its actual position.try this instruction if this does not helps then printer needs to be serviced by a locaL Printer servicing /reparing store
1: Remove the Cartridge 2: Unplug the AC Power Cord 3: Close Front access panel, Hold down the RESUME / RESET button and plug in the AC power cord 4: Release RESUME / RESET after plugging in the AC Power cord. 5: Press the RESUME / RESET once within 5 seconds and release the RESUME / RESET. 6: Press and HOLD RESUME / RESET for two seconds or more and release it. 7: Press and HOLD RESUME / RESET for two seconds or more and release it. 8: Unplug AC Power Cord to set data.
Testimonial: "It's work for me. Thank's for your advice"
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Several suggestions here include printing a heavy card instead of regular paper, or turning the printer upside down to remove any object like a key stuck in the printer.
Service Error 5202 solution for ip1800 / ip1900<br />
<br />
Steps:
<br />
1. turn-on printer, still blinking and a error message on screen, open cover.
<br />
2. While printer cover is open, unplug the power cord at the back. Of course it
<br />
turns off.
<br />
3. Remove all cartridges, clean the contact points and then insert them back
<br />
properly. Move the entire cartridge to its parking area.
<br />
4. Close the printer's cover, plug the power source, turn the printer on.
<br />
<br />
5. It should be working fine now. Mabuhay!!!
Hi. I have researched on it and found that the procedure below resets the waste ink absorber most of the times and that too automatically. Hope it helps.
Select the connected USB port number from USB PORT
Click LOCK RELEASE, and select the applicable model name in SET DESTINATION
In CLEAR WASTE INK COUNTER, select MAIN or PLATEN. The selectedwaste ink counter will be reset. MAIN resets the main waste inkcounter, PLATEN resets the platen waste ink counter.
If both the main and platen waste ink absorbers are replaced, reset both the main and platen waste ink counters.
I have Canon PIXMA MP210 printer but problem is that whenever i given comand for print or scan than computer show "Code: 2,114,0" this message therefor printer not print or scan. so please give me solution
you can solve this error code by removing the purge unit (take care of the ink).
Then you have to turn upside down the unit to check the gears. There is a white gear that moves in the ''air''. you have to re adjust the gear to transfer the move normally.
Then the problem dissapears.
Also you have to check if the motor is still moving.
×