Bose 3-2-1 Remote Control stopped working

It's not uncommon for the contacts between the remote sensor board and the main board to go bad on these units. You will probable have to take it in to get it looked at.

Get the same one as the original

hey Mark sounds like the antenna poped loose ..its a solder thing..[1]bose might fix it $45.[2]ebay replace $100 & up [3]i will list one tomorrow on amazon $105. total factory refurbished [4] return your old one for a$25 recycle + i pay the shipping........amazon bose remote [email protected]

$60 delivered...

http://cgi.ebay.com/Gen-Bose-RC38T1-27-Remote-Control-Lifestyle38-48-35-/270732947308?pt=LH_DefaultDomain_0&hash=item3f08f0ef6c

or try this advice to resuscitate your old one:
http://remotes.com/remotes/servlet/rs?a=Display&contents=help_deadremote&uuid=A12954406270641
"Dead" Remotes Can Be Saved
How to Re-Start Your "Dead" Remote Control
This only takes about a minute and will restart 1 in 3 "Dead" Original Remote Controls. Good Luck!
-----------------------------
Step 1- Pull the batteries out of the remote and leave them out until Step 4.
Step 2- Press and release each and every button one at a time on the remote control until every button has been pressed and released at least once!
Step 3- If your remote has slide switches, you must move the switch to each position then repeat the button pushing in Step 2.
(When you're done, be sure to put the slide switch in the correct position to operate the unit the remote came with!)
Step 4- Put the batteries back into the remote, being very careful to install them correctly.
New batteries should be used if you're not sure about the old ones.
Step 5- Try the remote.
Special Note:
If you have a digital camera, camcorder or camera phone you can test the remote to see if it is emitting a signal. Face the remote towards the lens of the digital unit until you can see the front of the remote. Depress any button on the remote. You should see a light (steady, blink or flashing) being emitted from the remote. If you do then the problem might not be the remote but the sensor on the unit.
If it works, Great!

See this link

http://remotes.com/remotes/servlet/rs?a=Display&contents=help_deadremote&uuid=A12963989782821

To convert Bose 3-2-1 GS Series 2 DVD system to Multi-Region playback

1. Press the Right button on your remote control
2. Press the Up button on your remote control
3. Press the Shuffle button on your remote control
4. Press the Stop button on your remote control
5. Press the Mute button on your remote control
6. The disc tray should eject twice to confirm the region change
7. Press the Standby button on your remote control to power off your machine
8. After one minute, press the Standby button on your remote control to power on.

Done!

A new remote is the simplest and best bet. I know of no way to repair a remote without making it irreparable. Though you might check the infrared LED i the front. Does the light on the remote illuminate when you press a button?(assuming it has that.)

Yes Contact Bose They will Help you. I also have a Bose,but if the receiver is Built by ONKYO and you have had this for more than a year you might have a problem. They(onkyo)require a receipt. The Techs are fine but the lady you will end up talking to is well just say not so nice. Good Luck

But a new remote. Non repairable item. Just worn out.

When we try to use the remote the red light glows which I never saw glowing when it was working properly.What could be the problem?