Symphonic - 19 televison, B 19WM

One For All Remote Emerson TV Codes: 0236, 0463, 0019, 0154,0177, 0178, 0179, 0180,0181, 0182, 0183, 0185,0270, 0280, 0282, 0158,0038, 0039

One For All Remote Symphonic DVD Code: 0675

SYMPHONIC Codes: 033/ 053/ 189
Let me know if you need further assistance.

Hello
You just buy one Philips Universal Remote control [MODEL NUMBER CL 034]. Symphonic is listed in its codes. Codes are: 0906 0520

Direct Code Entry

1. Press and hold the CODE SEARCH

button until the red indicator stays

on, then release the CODE SEARCH

button.

2. Press and release the desired Mode

button (TV, VCR, etc.). The red

indicator blinks, then stays lit.

3. Enter the 4 digit code from the code

tables. Note: after a valid code entry,

the red indicator turns off. For an

invalid code, the red indicator

flashes.

4. With your device on, press

CHANNEL UP. If the device

responds, no further programming is

required. Note: If some buttons do

not operate your device, try one of
the other codes for your brand.
OK.

You have a vertical deflection issue on both. Sounds like a bad capacitor. This repair is tricky but not expensive. Have a shop check it for you. Thanks for using fixya.

Hello,

If this is a Symhonic TV set, here ya go.

http://www.symphonic.us/pdf/om/ST131E.pdf

http://www.symphonic.us/pdf/om/6413TE.pdf

It looks like these are the same.

I hope this helps,

Cheers.

d tv

jumbo universal remote code for 19inch tv

It can be the remote sensor, or the circuitry that works with it. I don't know its exact location for your model, but you can usualy find it, because at its location it looks like a little black or dark red window in front of it.

The sensor and its related circuitry are servicable. To find the exact fault will require using a DVM and an oscilloscope to trace down where the signal is stopping from the sensor. The sensor feeds the main uPC controler via a number of components on the circuit board. An experienced service tech should be able to troubleshoot this for you, and replace the defective parts. On rare occasions the fault can be with the uPC itself.

It is also possible that there is a cold solder connection on the circuit board that is stopping the remote sensor from getting the remote signals to the uPC.

Jerry G.

scroll down on the channel button from channel 2. the different aux inputs should be there.there may also be a video/line in/source button on the front of the tv.if there isn't, you can buy a cheap universal remote for under $10 [even in some dollar stores for $1]
wg

It's shop time if you cannot adjust the set to your liking. Also, the noise that it's making now is a new ocurrence? Definitely needing a service call then...accordianman