After the detaling my navigation stoped working

Sounds like a door lock actuator motor not working properly inside the door. The door assembly will have to be dissassembled for inspection

Is there a possibility you erred in reassembly and shorted a wire inside the unit which in turn blew a fuse in the car somewhere?

I see you are ale to see the cables and rods how and when they operate. When you to open the latch from the outside and the inside. Are you able to see if they move the mechanism up or down as you try to open the door working the latch outside and the inside door handle. Sounds like your door latch broke internally, the only thing I was able to do was from the inside with somebody holding the outside latch up to open. Kick it hard in the area where the door latch is. Lay on the sit and kick it hard while the outside individual lifts the latch and pulls. It should pop open. Good luck.

try cleaning the grounds

If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

Click the link below :----http://wikisolutions.blogspot.in/2012/02/get-free-answers.html

probbably needs tune up
check with scan tool for missfire
could be plug/wire/coil

also, what engine do you have? It makes wiring diferences.

The air chambers are worn out and this has caused a heavy load on the compressor, causing IT to become loud. The relay could be oxidized from excessive runtime...accordianman

check your fuses, if thats not it, change the bulbs. good luck

take door lock switchs apart and clean contacts with wire brush and PDblast and then check for power at door switch