hotpoint wma 22, spins fast when empty but when 1 heavy item in just turns slow, replaced the bushes and the belt, still the same. any ideas.hotpoint wma 22, spins fast when empty but when 1 heavy item in just turns slow, replaced the bushes and the belt, still the same. any ideas.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try checking the filter for a blockage or pump being jammed with a button , disconnect drain hose at sink hold a few feet off ground over a bucket should pump/ flow quite freely if not then check filter and pump. good luck
Hi if your Beko Wm & Wma Models washing machine wont drain or has a spin problem then you have to check the carbon brushes first.
Also check all waste pipes are clear and inspect the pump I have included this video below.
At our website I am doing self diagnostic videos on these beko's as we speak so all tutorials will be in this link below How to replace Beko Washing Machine Motor Carbon Brushes
you might find this test video helpful but only do it if you have checked the motor
First, make sure your machine is not overloaded. Overloading will not allow the machine to spin out properly. Also, make sure its fairly level. Next, make sure that all the shocks on the drum are properly attached and in working order (after you pull off the access panel, the shocks are readily visible -- there are typically 4 of them, 2 in front, 2 in back). Their heads slip into a slot and then twisting them locks them in. Finally, I would pull of the drain line leading from the drain filter to the tub basin. Once its off, stick your hand up into the basin. All kinds of yuck tends to collect there, semi-obstructing the drain line, which permits more water to remain in the basin, which doesn't allow your machine to spin as quickly as it otherwise would.
Hi if your Beko WME7247W washing machine wont drain or has a spin problem then you have to check the carbon brushes first.
Also check all waste pipes are clear and inspect the pump I have included this video below.
At our website I am doing self diagnostic videos on these beko's as we speak so all tutorials will be in this link below How to replace Beko Washing Machine Motor Carbon Brushes
you might find this test video helpful but only do it if you have checked the motor more beko test videos at site
try cleaning your filter in washing machine,if this dosent fix problem,sounds like you need a water pump,i have had a front loader for 8 years now and had the same problem,with me finding the filter with alot of cloths lint,and other things it was stopping the water pump from pumping out water,try cleaning first and checking water outlet hose were water is pumed out might be blocked with a coin,these few steps before you spend money on water pump.
hope this helps you.
Sounds like it is trying to drain water. Pump filter is probably clogged. Washer wont work properly if it thinks water not draining all the way. Pump assemblies usually are at bottom behind lower front panel. Remove pump cap and filter, clean and reinstall. Should solve problem.
ok lets see here im onthejob,,i take it that cycle stops with suds..ok first are we using he or low sudsing detergent,,,next when you clean pump filter did you check pump wires for defectives,,,try and bleach unit out to get rid of slugg...also check connection to pressure switch,,and ccu...keep me posted..onthejob
where would i find this?
hotpoint wma 22, spins fast when empty but when 1 heavy item in just turns slow, replaced the bushes and the belt, still the same. any ideas.
×