Purchased in 2001, first time with a problem. Ran a self clean on top oven with no problems. Both ovens work, oven lights work, keep warm burner works and red light on panel goes on when keep warm burner is turned on.. Left two burners work. Right two burners (including inner and outer elements of large fron burner) do not work. Panel lights for all four burners do not work. Hot surface warning lights do not work. Followed reset features to restore factory defaults in case that was an issue, turned off breaker to stove for several minutes and turned backed on in case that was an issue.
You may want to re-seat the right two cooking elements, in case there is poor electrical contact. When you have them removed, clean the contacts with denatured 91% alcohol and a Q-tip. The removal procedure follows.
First, unplug the range.
LIFT–UP PORCELAIN COOKTOP
To lift: When cool, grasp the cooktop front
edge. Gently lift up until the two support rods
snap into place.
To lower: Hold the cooktop front edge and
carefully push back on each support rod to
release. Then lower the top into place.
COIL ELEMENTS
➢When an element is on, it will cycle on
and off to maintain the heat setting.
➢Coil elements are self-cleaning. Do not
immerse in water.
To remove: When cool, raise element. Carefully pull out and away from receptacle.
Check them for damage. They do wear out.
To replace: Insert element terminals into receptacle. Guide the element into place. Press down on the outer edge of element until it sits level on drip bowl.
COIL ELEMENT SURFACE
➢ On Canadian models, the two front elements will not operate during self-clean.To prevent the risk of electric shock or fire, never line drip bowls with aluminum foil.
If that does work, you may have a faulty control panel. In that case, call Maytag at the number below.
Maytag Customer Service
533 Benson Road
Benton Harbor,MI 49022
(800)688-9900 U.S.
(800)688-2002 Canada
316 views
Usually answered in minutes!
×