How do I retrieve my messages remotely - Lands Phones

Retrieving Messages on the Answering Machine
Press and hold either the "Answer L1" or the "Answer L2" button, depending on the line from which you want to retrieve messages.
Retrieving Messages on the Answering MachinePress and hold either the "Answer L1" or the "Answer L2" button, depending on the line from which you want to retrieve messages.

dial the phone (use a cell for test run/practice) ...once you hear the message press "*" (the asterisk key) and enter your 4 digit code (the default code is 1234 or sometimes 0000) you really should change this, this might have been done in the initial setup... read your manual for the exact commands to be use after/during retrieving msg....

The remote operation instructions are on the right half of the first page of the manual at
http://www.radioshack.com/graphics/uc/rsk/Support/ProductManuals/4303829_PM_EN.pdf

It's either a message stored on the device itself, or you unknowingly have remote voicemail with your phone service provider.

Call your phone company or visit their website for instructions on how to retrieve remote voicemail.

Full remote operation means you can retrieve, delete and save messages or change announcements from any touch-tone phone. just press the full remote option and check out for the  deleted message in it.it will show up if it still saved in memory.

Remote code
A remote code must be entered when operating the answering system remotely. This code prevents unauthorized parties from listening to your messages remotely. Store any 2-digit number (00–99). The default setting is “11”.

1 Press {MENU}.
2 Scroll to “Initial setting” by pressing {V} or {^}, then press {>}.
3 Scroll to “Set answering” by pressing {V} or {^}, then press {>}.
4 Scroll to “Remote code” by pressing {V} or {^}, then press {>}.
5 Select the desired remote code by entering a 2-digit number (00–99).
6 Press {Save}, then press {OFF}.

Note:
To confirm the remote code, repeat steps 1 to 4. Press {OFF} when finished.

Check if message retrieval works with a landline phone. If that works, then either the tones generated by your cellph are too far off frequency, or the cell network is filtering out or compressing too much of the tones.

30 seconds with a search engine got this page http://www.uniden.com/index/manuals_results.cfm?cat=59

Put in your model number and you're good to go.

Carl

To connect with your answering system:
1 Dial your telephone number from a touch tone phone. 2 When the system answers, enter your Remote Access Code. The system announces the number of messages and begins message playback. 3 Listen to your messages
Change remote access code Press [*] [#]. Follow prompts to set new code.

i found my solution on the AT&T website.
thanks anyway.