My shop not regerster at bargaining counsel for 10 years and my stuff what will happen if they found out

If you're dissatisfied with her charges, ask her why she is doing it and why you should not be looking for a new hairdresser.

Sounds like you have a short in the wiring. This is repair shop stuff, or buy a new camera time. Usually, if it is a point and shoot , it is not worth sending for repair as you'll playas much as a new camera is worth. I would look for a new camera, personally. Good luck.

I had a colleague who's wife quit work as an assembler to start a hairdressing shop. It took all of their monetary resources and put them in divorce court.

Another colleague has a long time girlfriend who worked many years, built up a customer base and owns her own shop. She doesn't make much extra money.

Pretty much any barber shop or hairdresser should be able to give you a mohawk. Just be specific when you ask for it and make sure the person doing it understands exactly what you want.

Isn't there any option to up the volume? I think it would be a waste to repair that old thing. go to a store or contact an online shop for advice :)

Well clean the gamepacks out with qutips and rubbing alcohal.

if this is a traditional top load washer, then your lid switch might be bad. Usually when this happens, your washer will start fine. Your put it for a normal wash, it does its thing, lets in water, and agitate and stuff, but when it goes to the spin cycle. it stays in that cycle and wont advance. Leaving you with a tub full of water. Like i said if its a traditional top load kenmore, the lid switch is the the gray looking part when you open your lid. when you open your lid, youll see two screws holding it. But you have to take the whole shell of the waher to get to it....take 2 screws on the back corners of the counsel, then flip the counsel up. Locate to metal clips and pop them put with screwdriver. unclip the lid switch connector located by the clear hose that runs down. then lift and pull the whole shell towards your and acess the switch from underneath. put back together how you took it apart.( MAKE SURE THE CLEAR HOSE THAT RUNS FROM THE TOP COUNSEL TO THE TUB DONT GET PINCHED BECAUSE YOUR WASHER WILL OVERFLOW WITH WATER) like i said if its a tradidonal top load kenmore....hope this helps