Xerox docucolor 252 code 094 321 - Xerox Computers & Internet

SOURCE: want to copy images from notebook paper without blue lines apparent

yes, you are loking for border erase function. when you find it then look for what looks like two peices of paper side by side, you will then possible be allowed to adust the sixe of the erased area

SOURCE: docucolor 252 fault code 047-310

This error code indicates that the Xerox is not communicating with the finisher. The recommended method to resolve this is to power off the Xerox, wait 3 minutes after power is off, unplug the machine from the wall, wait 1 more minute and plug in and restart. If that does not help, it will require a call to the service number: 800-821-2797

SOURCE: Fault 127-210. Printer functional but can not connect to command Workstation.

i think it is the problem of Fiery installation

recently i am gone through the same

but i got some other code

u can try by installing fiery

SOURCE: Xerox DocuColor 3535 Copier Problem

116-325 RAP An error occurred in ESS fan rotation:---------Try reset procedure:-- to correct your issue:
Simultaneously press and hold the 1, the Stop, and the Power Save buttons on the Control Panel.
---------
If the problem persists try:
-------
Hold the 6, the Stop, and the Power Save buttons.If still it comes again,---------
Hold the 4, the Stop, and the Power Save buttons .If still it comes again ,-------
Hold the 3, the Stop, and the Power Save buttons .If still it comes again then there is internal problem with cooling fan .The ESS fan module has to be replaced.The part number for ESS fan module is 127K32920.To order this part you can order it from online website.click this link directly to order the parts:---

http://www.iteminc.com/parts_docucolor_1632_2240.htm
----------------
this will help.Thanks.Helpmech.

SOURCE: I am sending files from

Hi Pat,
We had a problem in our print shop similar to this, it was caused by the heat when the toner is fused to the paper, it actually shrunk the image from heat. To test this theory try running the job on the heaviest card stock you have and see if it is still smaller. In any event the only way we could work around this was to send all jobs out at 100.6% on text and 100.4% on card stock. I was told unofficially that the update from xerox actually does something similar to this but only works when the image is copied off the glass. You may have to adjust the percentages and also make sure that you are setting the copier to the closet gsm of your stock. The heavier the stock the more heat it needs to fuse the toner, so try running on the lowest gsm setting you can; but beware if you set it too low the image will scratch off the paper.
Thanks for using FixYa,