The on-off button on my Sangean RCR-2 now requires being pushed in many times before it will turn on or off. How can this be fixed?

here is a link to instructions. copy and paste. you could remove battery to rest clock and start over paying attention to page 15
https://www.manualslib.com/manual/147883/Sangean-Rcr-1.html#manual

Do a factory reset followed by a 5am alarm setup

www.sangean.com/support/.../Manual

not be the maximum volume but it only poniendole an audio amplifier

I think the white cord is the fm antenna. The gray one with the thick end is the am antenna. The frequency used to contact the atomic clock signal uses the am antenna.

Underneath make sure the switch is set to your time zone. Also check the day light savings setting.

I just had the same problem which you find posted here on FixYa.com. The problem solved itself overnight for me. I left the RCR-22 unit plugged in and searching for the signal when I woke up the next morning the time was set and the Atomic signal indicator was solid instead of flashing. It has kept perfect time since then. My only issue is that setting the alarm clock-radio is complicated.

Robert Hovestadt

You can get the manual on the link below.

http://www.thiecom.de/ftp/sangean/rcr22/rcr22-manual-e.pdf