How do I set time please on Polaroid cr01 alarm clock

Question edited for clarity.

There are no manuals online. So ask direct.

For FM radio reception, you need an aerial. or you will just get static.

https://tzumi.com/contact-us/

UNLESS the model is actually 6696DG?

..
More here

https://www.google.com/search?q=tzumi+am%2Ffm+radio+alarm+clock+manual

..

On what device?

hi cheryl.
this is all i could find,if this does not work go to the link and the bottom.
How to set time on sharp alarm clock? Change switch to BUZZER. 3.) Press and hold the ALARM button on top of the clock. 4.) Press HOUR button until desired hour is displayed.12 Feb 2013

Sharp Alarm Clock Inustructions by Matt Boysen on Prezi

https://prezi.com/vgxxmjfbc1ya/sharp-alarm-clock-inustructions/ Search for: How to set time on sharp alarm clock?

instructions setting sharp alarm clock SPC293 Google Search

Hi Annmarie

here is a link to a similar polaroid clock. hope it helps
http://www.southerntelecom.com/polariodsupport/downloads/PCR210.pdf

I have just spent quite a while figuring this out. With the alarm/radio in the office state (just with the time and no radio or buzzer on) if you press the vol - alarm 1 button briefly it will flick through the current settings of the alarm 1. Whilst it is doing this press the vol - alarm 1 again and this turns alarm 1 off (the al1 light on the left of the time display should turn off to confirm that it has worked). For alarm 2 repeat the above steps but using the vol+ alarm 2 button. I had to share this as I could not find any answer or a manual on line.

Here's how I found it. Web search "rca rc05 manual".

http://www.payphone.com/shop/instructions/RCA-RC05.pdf

press the top button on the right until the radio comes on, then set the alarm time.

Hold CLOCK SET button down, press HOURS and MINUTES until you get the right time, release CLOCK SET button. This radio alarm unhelpful calls the ON/OFF button "STANDBY"! To turn it on, press the STANDBY button so the standby light is on!

Following are the instructions for the RP5610 which looks very similar to the 4801A (that I also have). The only difference in the instructions is that the 4801A doesn't have a clock icon, just press the SET button until the center colon dots are flashing, Press the rewind or fast forward arrows on the circle next to it to set the time. Set the alarms by pressing the set button until bell 1 or 2 is displayed. Nap is also set with the set button - not sure how to stop it yet.

To set the clock:

1. Press the SET button until the clock icon is displayed (circle with hands at 10 and 2)
2. Press |<< REV or >>| FWD to set the time.
3. AM or PM icon will show besides the time.