Free user manual for DORO 540R+3 phone home base plus 3 other handsets

Open the battery comparment on the handset. Under the
battery there should be a small sticker with the model
number. Take this number to www.manualslib.com and
you'll be able to download the original users' manual....
which will then answer many questions.
Good luck!

You might try to de-register the handset and re-register
it to the base. Be sure the handset's battery is well
charged, a weak battery can impede the registration.

( I ) To de-register the errant handset:

1. Press and hold the [END] and [ # ] keys at the same time until the screen displays
"System Reset, Deregister Handset"
2. press [select]
3. scroll to "Base Unavailable"
4. press [select]
5. display says "Not Registered"

( II ) To register the handset to the base:

1. open the base display's [menu]
2. scroll to "Register Accy."
3. press [select]
4. on the handset, press and hold [ # ] until
the handset display says "Registering"
5. In ~30 seconds, handset display will say
"Registration Complete" or
"Registration Failed".

This is described on page 22 of the manual.
A free copy of the User's Manual can be obtained
at www.manualslib.com .

Good luck!
------------

Hey what u doing

Hello

Ok, you will be able to download the manual at the link below.

Click HERE to navigate to the3 download page.

Kind regards
Andrea

Hi I have a manual do you still need one I can scan this one if you like. Allan.

Hi, 

this should be what you've been looking for

http://www.home-electronics.net/ge/pc/IB/28112EE3_IB.pdf

If it's not the right model here are the other manuals

http://www.home-electronics.net/ge/pc/user-manuals.asp

You will find your model number on the bottom of the Base or Handset Charge Cradle of your phone

Press and hold sound button until P appears then press B phone book symbol Enter number to remember press B to confirm allocate short cut number and B confirm

I don't have a second handset, but I'll quote from the instruction manual - Try this,

Regsiter up to 5 GAP cpmatible handsets to your OT150 base. New handsets must be fully charged.

You can use the same handset at home as well as the office by registering it to 2 bases.

1. At the base: press and hold "FIND HANDSET". You hear 2 beeps and the in use light flashes. Youa re now in registration mode.

2. At the handset: Press "OK". scroll down (with down arrow) to "REGISTRATION" and press "OK".

3. "REGISTER" is diplayed. Press "OK". Any free base numbers will flash. Enter the number of the base you want using the keypad.

4. Enter the PIN Number (default = 0000) and press "OK"

5. The handset searches for the base and when registration is complete goes into standby mode.

To test the handset is registered. Press "FIND HANDSET" on the base and the handset should begin to ring. Press "FIND HANDSET" again to stop the ringing.


As I say this is taken word for word (with a few spelling mistakes no doubt) from the instructions. I Hope that it solves your problem.

If you still have problems or you don't have the PIN number, the helpline number is 0845 226 7794, or e-mail [email protected]

Go to http://www.doro.com.au select home phones then Support then Manuals Then you type in your model which should be on the back of the base unit.

Check that you have the larger power adaptor connected to the base unit.