What is error code F63 on Frigidaire oven - Frigidaire Ovens

Error Code: F3

Solution: The oven temperature sensor may be failing or defective. First, check sensor harness and harness connection between oven sensor and oven control to see if there is an issue with loose wires or visible damage to the wiring, such as a burnt wire.Sep 1, 2018

Frigidaire Error Codes Explained - D&T Appliance Service

..

Question edited for typos. However "turn back"??
Frigidaire Error Codes

Error Code: F0, F1, F5, F6

• Code Description: Electronic oven control failure
• Solution: These codes indicate a malfunction in the electronic oven control. The electronic oven control (EOC) may also be referred to as circuit board, control board, mother board, ERC, or clock. Unplug the appliance for about 10 minutes to see if the error code will reset itself. When you reconnect the power, if the error code is still displayed, you can test the temperature sensor with an Ohm meter to determine if it has the proper level of resistance. If the oven control is failing or defective, replace it.

Also says Relay Board fault

https://www.google.com/search?q=Frigidaire+oven+error+of+F5

..

ignitor is what popped replace

F4 is a temp sensor error. you can find more info here
https://appliancerepairinfo.com/lg-oven-error-codes

Good Afternoon Friend, this is Z. I am happy to assist you!

I understand you are seeking a site that provides a listing of error codes on your Frigidaire oven. This information is very rare to find. Is your oven receiving an error code? If so, may I have the error code and with this information I'll be more than happy to help you narrow down the possibilities of the code. Thank you!

Hello friend, thank you for your post!

I see you have a Frigidaire wall oven and you are searching for error codes. Do you have a specific error code that your oven is giving you? Also, could I get your model number please? With that additional information I would be able to provide you more assistance. I look forward to hearing from you. -Matt

overheat situation. check oven sensor and soldered pin points for sensor wires at relay board. Resolder if needed.

Hello steve o - Typically error code F11 indicates a shorted keypad. Try resetting the range by unplugging it or flipping the household circuit breaker off. This usually will clear most false error codes. Wait approximately ten minutes and if the error code does not clear contact a professional to move forward accurately. Most likely the EOC on the range will need replacing.

change clock

Frigidaire / Westinghouse / Tappan / Gibson
Oven Fault Codes
Display Condition Remedy
F0 & F1 EOC failure Replace EOC
F2 Oven over heat Defective Sensor or EOC
F3 Oven Sensor Open Replace Sensor
F4 Shorted wire or Sensor locate short and correct it
F5 EOC failure Replace EOC
F6 EOC failure Replace EOC
F7 EOC failure Replace EOC

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61