My nec P502H projector not working while it hook on ceiling but on the table its working fine.can u just help me ?

Connect a laptop then go into the settings menu, usually in the display section. The heading might be orientation. Depending on if you are table, ceiling, rear or forward mounting the projector will determine which orientation you will need. I have various NEC models, if you need furher info I can set one up and find the specific area in the menu. There is also very good support from NEC website with downloadable manuals

Sounds like you have to scroll thru the video settings upside down is the setting for projectors mounted on the ceiling simple fix though you may have to stand on your head to read the setting options :0)

hi,
1. press menu button
2. select setup
3.go to orientation (This sets your image for your type of projection. The options are:
desktop front projection, ceiling rear projection, desktop rear projection, and ceiling front projection.)
ok,

The NP2000, like most projector, can be set for table top, or ceiling mount, and front or rear projection. It sounds like you have a problem with the mounting orientation.

1. Open the Basic menu.
2. Select "Setup"
3. Select "Installation" tab.
4. Select "Orientation"
5. Select the orientation that best meets your situation. The choices are Desktop front, Desktop Rear, Ceiling front, and Ceiling rear.

You can download the manual here.

The only I can think of is the resolution setting that your T400 is putting out that your NEC does not like andcannot display, look at the T42 resolution when the NEC is hooked up to it and try to set it to be the same in the T400.

If you go onto your menu and click on "setup". Press orientation and select the right one for your projector. It allows you to choose whether your projector is on a table top or ceiling mounted etc.

YOU most likely have the thing mounted upside down that all
just flip and check the instructions

>if it is hooked up through a pc you will have to change the settings in on the pc( graphfic/diplay) ROTATE 90degress


PLEASE be kind if i helped and post more if you need help RATE this userKindofcheap

Hi paulveldt

Very easy ! Simply go into the menu and look for the subfolder that will either read Mirror or Flip Image. Scroll down to it and press left or right until the image is back to normal.

A mountable Projector can project flat fronted ( on a table ) upside down ( on the ceiling ) rear ( from behind - on a rear projection screen ) and upside down from behind ( from the ceiling onto a rear projection screen )

This should do the trick !

Thanks for using Fixya !

go into menu, under image, and chose ceiling.

in amodel nec projector vt490 the status lamp is blinking or flashing and the machin not work
plz send me the problem and solusion.